Modification of flow behind a circular cylinder by steady and time-periodic blowing
- 1 November 2021
- journal article
- conference paper
- Published by AIP Publishing in Physics of Fluids
- Vol. 33 (11) , 115126
Abstract
We apply steady and time-periodic blowing, respectively, to flow over a circular cylinder at a Reynolds number of 21 000 for the modification of flow in the wake. The blowing is applied near the separation point on the upper and lower surfaces from either a slit (uniform blowing) or eight holes (discrete blowing) along the spanwise direction at each surface. For steady blowing, the blowing momentum coefficient ranges from 0.008 to 0.269, and, for time-periodic blowing, it does from 0.013 to 0.162. The changes in the drag are estimated by a momentum theorem with the velocity measurements in the wake. The steady discrete blowing is more effective and efficient for drag reduction than the steady uniform blowing, providing a maximum drag reduction of 38%. Counter-rotating vortices induced by the optimal discrete blowing change the Kármán vortex cores into three-dimensional vortices and weaken their strength. On the other hand, steady uniform blowing significantly increases the wake width and leads to drag increase. With time-periodic blowing, the maximum drag reductions by uniform and discrete blowing are 68% and 28%, respectively, indicating that the time-periodic uniform blowing is more effective than the steady discrete blowing. For the time-periodic blowing, two different vortex lock-on phenomena (symmetric and asymmetric vortex shedding in the wake) are found, and they lead to a significant drag decrease and increase, respectively.Keywords
Funding Information
- National Research Foundation (2019R1A2C2086237)
This publication has 41 references indexed in Scilit:
- Fluid forces on a very low Reynolds number airfoil and their predictionInternational Journal of Heat and Fluid Flow, 2011
- Circular cylinder vortex-synchronization control with a synthetic jet positioned at the rear stagnation pointJournal of Fluid Mechanics, 2010
- Spatially distributed control for optimal drag reduction of the flow past a circular cylinderJournal of Fluid Mechanics, 2008
- Control of Flow Over a Bluff BodyAnnual Review of Fluid Mechanics, 2008
- Drag reduction in flow over a two-dimensional bluff body with a blunt trailing edge using a new passive deviceJournal of Fluid Mechanics, 2006
- Distributed forcing of flow over a circular cylinderPhysics of Fluids, 2005
- Flow past a square-section cylinder with a wavy stagnation faceJournal of Fluid Mechanics, 2001
- Determination of drag of a circular cylinderAIAA Journal, 1990
- The locking-on of vortex shedding due to the cross-stream vibration of circular cylinders in uniform and shear flowsJournal of Fluid Mechanics, 1976
- A theory of circulation control by slot-blowing, applied to a circular cylinderJournal of Fluid Mechanics, 1968