Maximum acceptable forces of dynamic pushing: comparison of two techniques
Authors:
- Raymond W. McgorryRMRaymond W. Mcgorry
- Susan E. MartinSMSusan E. Martin
- Ilya B. BezverkhnyIBIlya B. Bezverkhny
- 1 January 1999
- journal article
- research article
- Published by Taylor & Francis in Ergonomics
- Vol. 42 (1) , 32-39
Abstract
The purpose of this experiment was to investigate maximum acceptable initial and sustained forces while performing a push of 7.6 m, performed at a frequency of 1 push min-1 on a magnetic particle brake treadmill and a high-inertia push-cart. Eight male industrial workers performed a 40 min treadmill pushing task in the context of a larger experiment and two, 2 h push-cart tasks with a unique water loading system. A psychophysical methodology was employed, whereby the subjects were asked to select a workload they could sustain for 8 h without straining themselves or without becoming unusually tired, weakened, overheated or out of breath. The results revealed that maximum acceptable initial and sustained forces of pushing on the high inertia cart were significantly higher (28 and 23%, respectively) than pushing forces on the magnetic particle brake treadmill. It was concluded that adjustments to the pushing and pulling data bank by Snook and Ciriello (1991) may be appropriate if verification of this experiment yields similar results.Keywords
This publication has 17 references indexed in Scilit:
- Psychophysical studies of repetitive wrist flexion and extensionErgonomics, 1995
- The evaluation of a practical biomechanical model estimating lumbar moments in occupational activitiesErgonomics, 1994
- Measurement of trunk bending during work by direct observation and continuous measurementApplied Ergonomics, 1992
- The design of manual handling tasks: revised tables of maximum acceptable weights and forcesErgonomics, 1991
- Analysis and improvement of work postures in the building industry: application of the computerised OWAS methodApplied Ergonomics, 1991
- The physical and physiological workload of refuse collectorsErgonomics, 1990
- The effects of task duration on psychophysically-determined maximum acceptable weights and forcesErgonomics, 1990
- The Ergonomics Society The Society's Lecture 1978. THE DESIGN OF MANUAL HANDLING TASKSErgonomics, 1978
- A Study of Three Preventive Approaches to Low Back InjuryJournal of Occupational and Environmental Medicine, 1978
- Maximum Weights and Work Loads Acceptable to Male Industrial WorkersAIHA Journal, 1970