Solvent‐Assisted Laser Drilling of Silicon Carbide
Authors:
- 22 October 2010
- journal article
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 8 (6) , 1263-1276
Abstract
Laser drilling of single crystalline silicon carbide (SiC) wafer in air, under water, and under methanol with a 355 nm wavelength laser is investigated and compared. Among these different media, laser drilling of SiC under a solvent, methanol, is found to produce holes with a relatively cleaner and smoother surface. Ablated particle redeposition at the entrance and exit of the holes is minimized. Minimum oxide (i.e., silicon dioxide) or heat‐affected zones are observed and the surface finish inside the holes is much smoother and more uniform as compared with those drilled in air and under water. The improvement of drilling quality can be attributed to the relatively lower boiling temperature and better wettability of the solvents, which enhance the effects of cooling (thermal damage free) and ablated particle cleaning during laser drilling. It is found that the quality of laser drilling of SiC varied with the thickness of solvent layer, that is, water and methanol. A solvent layer of 500 μm is suggested to be used for the enhancement of laser ablation rate and quality.Keywords
This publication has 39 references indexed in Scilit:
- Influence of kinematic operating parameters on kerf geometry in abrasive waterjet machining of silicon carbide ceramicsInternational Journal of Machine Tools and Manufacture, 2009
- Laser irradiation of α-SiC ceramicsCeramics International, 2009
- Physical Effects of Multipass Two‐Dimensional Laser Machining of Structural CeramicsAdvanced Engineering Materials, 2009
- In‐situ surface absorptivity prediction during 1.06 μm wavelength laser low aspect ratio machining of structural ceramicsPhysica Status Solidi (a), 2009
- Laser machining of structural ceramics—A reviewJournal of the European Ceramic Society, 2009
- Analysis of materials modifications caused by UV laser micro drilling of via holes in AlGaN/GaN transistors on SiCApplied Surface Science, 2007
- Effect of beam angle on HAZ, recast and oxide layer characteristics in laser drilling of TBC nickel superalloysInternational Journal of Machine Tools and Manufacture, 2006
- High-Temperature Single-Crystal 3C-SiC Capacitive Pressure SensorIEEE Sensors Journal, 2004
- A closed form solution for laser drilling of silicon nitride and alumina ceramicsJournal of Materials Processing Technology, 2003
- Laser-induced surface drilling of silicon carbideApplied Surface Science, 2001