Deformation-induced phase transition and nanotwins in SS 304 steel during cryogenic laser shock peening without coating
Authors:
- M.V. NatarajMNM.V. Nataraj
- S. SwaroopSSS. Swaroop
Open Access
- 11 June 2022
- journal article
- research article
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 19, 2611-2622
Abstract
No abstract availableKeywords
This publication has 47 references indexed in Scilit:
- Thermodynamic modeling of the stacking fault energy of austenitic steelsActa Materialia, 2011
- Optimization of the strain rate to achieve exceptional mechanical properties of 304 stainless steel using high speed ultrasonic surface mechanical attrition treatmentActa Materialia, 2010
- Microstructure and mechanical behavior of Ti–6Al–4V produced by rapid-layer manufacturing, for biomedical applicationsJournal of the Mechanical Behavior of Biomedical Materials, 2009
- Fabrication of a gradient nano-micro-structured surface layer on bulk copper by means of a surface mechanical grinding treatmentScripta Materialia, 2008
- Microstructure of 1Cr18Ni9Ti stainless steel by cryogenic compression deformation and annealingMaterials Science and Engineering: A, 2005
- Comparison of rolling texture in low and medium stacking fault energy austenitic stainless steelsMaterials Science and Engineering: A, 2005
- Strengthening via the formation of strain-induced martensite in stainless steelsMaterials Science and Engineering: A, 2004
- High temperature fatigue behavior and residual stress stability of laser-shock peened and deep rolled austenitic steel AISI 304Scripta Materialia, 2004
- An in situ transmission electron microscope study of the thermal stability of near-surface microstructures induced by deep rolling and laser-shock peeningScripta Materialia, 2003
- Effect of pressure on the microstructure of an austenitic stainless steel shock-loaded by very short laser pulsesJournal of Materials Science, 1994