Microstructural characterization of titanium matrix composite coatings reinforced by in situ synthesized TiB + TiC fabricated on Ti6Al4V by laser cladding
Authors:
- 8 September 2010
- journal article
- Published by Wiley in Rare Metals
- Vol. 29 (5) , 465-472
Abstract
Titanium‐based composite coatings reinforced by in situ synthesized TiB and TiC particles between titanium and B 4 C were successfully fabricated on Ti6Al4V by laser cladding. Phase constituents of the coatings were predicted by thermodynamic calculations in the Ti‐B 4 C‐Al and Ti‐B‐C‐Al systems, respectively, and were validated well by X‐ray diffraction (XRD) analysis results. Microstructural and metallographic analyses were made by scanning electron microscopy (SEM) and electron probe micro‐analysis (EPMA). The results show that the coatings are mainly composed of α‐Ti cellular dendrites and the eutecticum in which a large number of needle‐shaped TiB and a few equiaxial TiC particles are embedded. C is enriched in α‐Ti cellular dendrites and far exceeds the theoretical maximum dissolubility, owing to the extension of saturation during laser cladding. The coatings have a good metallurgical bond with the substrate due to the existence of the dilution zone, in which a great amount of lamella β‐Ti grains consisting of a thin needle‐shaped martensitic microstructure are present and grow parallel to the heat flux direction; a few TiB and TiC reinforcements are observed at the boundaries of initial β‐Ti grains.Keywords
This publication has 25 references indexed in Scilit:
- Laser Cladded TiCN Coatings on the Surface of TitaniumActa Metallurgica Sinica (English Letters), 2007
- Laser cladding of Ni-base composite coatings onto Ti–6Al–4V substrates with pre-placed B4C+NiCrBSi powdersSurface and Coatings Technology, 2006
- Bioactivity of TiN-coated titanium implantsActa Materialia, 2004
- Properties of single layer and gradient (Ti,Al)N coatingsMaterials Science and Engineering: A, 2003
- TiC particulate composite coating produced in situ by laser claddingMaterials Science and Engineering: A, 2003
- Ti–6Al–4V strengthened by laser melt injection of WCp particlesActa Materialia, 2002
- Cladding of Ni–Cr–B–Si coatings with a high power diode laserMaterials Science and Engineering: A, 2002
- Microstructure and formation mechanism of in situ synthesized TiC/Ti surface MMC on Ti-6Al-4V by laser claddingScripta Materialia, 2001
- Laser cladding of Ti-6Al-4V alloy with TiC and TiC+NiCrBSi powdersSurface and Coatings Technology, 2001
- Composite layer formation on Ti–6Al–4V surfaces by laser treatment using prepiaced SiC powderSurface Engineering, 1997