Battery State Estimation for Lead-Acid Batteries under Float Charge Conditions by Impedance: Benchmark of Common Detection Methods
Open Access
- 6 August 2018
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 8 (8) , 1308
Abstract
Impedance or admittance measurements are a common indicator for the condition of lead-acid batteries in field applications such as uninterruptible power supply (UPS) systems. However, several commercially available measurement units use different techniques to measure and interpret the battery impedance. This paper describes common measurement methods and compares their indication for the state of health (SoH) to those of electrochemical impedance spectroscopy (EIS). For this analysis, two strings consisting each of 24 valve-regulated lead-acid (VRLA) batteries with a rated voltage of 12 V and about 7 Ah capacity were kept under standard UPS conditions in float charge for over 560 days. They were monitored continuously with a LEM Sentinel 2 and went into regular check-ups with impedance measurements by a Hioki BT3554 as well as electrochemical impedance spectroscopy (EIS) measurements with an impedance meter (μEIS). Today it is widely expected that solely the relative increase of the impedance reading is sufficient for the estimation of the available capacity. However, it can be shown that the measured relative increase deviates for different frequencies and therefore the choice of the excitation signal and measurement frequency does make a difference for the calculation of the available capacity. Finally, a method for a more decisive monitoring in field applications is suggested.Keywords
This publication has 17 references indexed in Scilit:
- Determination of SoH of Lead-Acid Batteries by Electrochemical Impedance SpectroscopyApplied Sciences, 2018
- Determination of the lead-acid battery's dynamic response using Butler-Volmer equation for advanced battery management systems in automotive applicationsJournal of Power Sources, 2016
- A critical overview of definitions and determination techniques of the internal resistance using lithium-ion, lead-acid, nickel metal-hydride batteries and electrochemical double-layer capacitors as examplesJournal of Power Sources, 2015
- Simulation of SLI Lead-Acid Batteries for SoC, Aging and Cranking Capability Prediction in Automotive ApplicationsJournal of the Electrochemical Society, 2012
- Influence of measurement procedure on quality of impedance spectra on lead–acid batteriesJournal of Power Sources, 2011
- Impedance measurements on lead–acid batteries for state-of-charge, state-of-health and cranking capability prognosis in electric and hybrid electric vehiclesJournal of Power Sources, 2005
- Aging mechanisms and service life of lead–acid batteriesJournal of Power Sources, 2004
- A method for measurement and interpretation of impedance spectra for industrial batteriesJournal of Power Sources, 2000
- A review of impedance measurements for determination of the state-of-charge or state-of-health of secondary batteriesJournal of Power Sources, 1998
- Float Charging of Valve‐Regulated Lead‐Acid Batteries: A Balancing Act Between Secondary ReactionsJournal of the Electrochemical Society, 1996