Elastomer-Embedded Multiplexed Optical Fiber Sensor System for Multiplane Shape Reconstruction
Open Access
Abstract
This paper presents the development and application of a multiplexed intensity variation-based sensor system for multiplane shape reconstruction. The sensor is based on a polymer optical fiber (POF) with sequential lateral sections coupled with a flexible light-emitting diode (LED) belt. The optical source modulation enables the development of 30 independent sensors using one photodetector, where the sensor system is embedded in polydimethylsiloxane (PDMS) resin in two configurations. Configuration 1 is a continuous PDMS layer applied in the interface between the flexible LED belt and the POF, whereas Configuration 2 comprises a 20 mm length PDMS layer only on each lateral section and LED region. The finite element method (FEM) is employed for the strain distribution evaluation in different conditions, including the strain distribution on the sensor system subjected to momentums in roll, pitch and yaw conditions. The experimental results of pressure application at 30 regions for each configuration indicated a higher sensitivity of Configuration 1 (83.58 a.u./kPa) when compared with Configuration 2 (40.06 a.u./kPa). However, Configuration 2 presented the smallest cross-sensitivity between sequential sensors (0.94 a.u./kPa against 45.5 a.u./kPa of Configuration 1). Then, the possibility of real-time loading condition monitoring and shape reconstruction is evaluated using Configuration 1 subjected to momentums in roll, pitch and yaw, as well as mechanical waves applied on the sensor structure. The strain distribution on the sensor presented the same pattern as the one obtained in the simulations, and the real-time response of each sensor was obtained for each case. In addition, the possibility of real-time loading condition estimation is analyzed using the k-means algorithm (an unsupervised machine learning approach) for the clusterization of data regarding the loading condition. The comparison between the predicted results and the real ones shows a 90.55% success rate. Thus, the proposed sensor device is a feasible alternative for integrated sensing in movement analysis, structural health monitoring submitted to dynamic loading and robotics for the assessment of the robot structure.Keywords
Funding Information
- Fundação de Amparo à Pesquisa e Inovação do Espírito Santo (2022-6PC5F, 2022-C5K3H, 2021-TBG0J, 310668/2021-2, 304049/2019-0)
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (2022-6PC5F, 2022-C5K3H, 2021-TBG0J, 310668/2021-2, 304049/2019-0)
This publication has 39 references indexed in Scilit:
- Analytical model for a polymer optical fiber under dynamic bendingOptics & Laser Technology, 2017
- 3-DOF Force-Sensing Motorized Micro-Forceps for Robot-Assisted Vitreoretinal SurgeryIEEE Sensors Journal, 2017
- Modified fs-Laser Inscribed FBG Array for Rapid Mode Shape Capture of Free-Free Vibrating BeamsIEEE Photonics Technology Letters, 2016
- Strain Measuring 3D Printed Structure with Embedded Fibre Bragg GratingProcedia Engineering, 2016
- Compact Optical Fiber 3D Shape Sensor Based on a Pair of Orthogonal Tilted Fiber Bragg GratingsScientific Reports, 2015
- Cladding waveguide gratings in standard single-mode fiber for 3D shape sensingOptics Letters, 2015
- Highly sensitive liquid level monitoring system utilizing polymer fiber Bragg gratingsOptics Express, 2015
- Multivariable Dynamic Ankle Mechanical Impedance With Active MusclesIEEE Transactions on Neural Systems and Rehabilitation Engineering, 2014
- Spatial shape reconstruction using orthogonal fiber Bragg grating sensor arrayMechatronics, 2012
- Cluster Structure of K-means Clustering via Principal Component Analysis2004