Pop-up assembly of a quadrupedal ambulatory MicroRobot
Authors:
- 1 November 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21530858,p. 1518-1524
Abstract
Here we present the design of a 1.27g quadrupedal microrobot manufactured using “Pop-up book MEMS” the first such device capable of locomotion. Implementing popup assembly techniques enables manufacturing of the robot's exoskeleton and drivetrain transmissions from a single 23-layer laminate. Its demonstrated capabilities include payload capacity greater than 1.35g (106% of body mass), maneuverability on flat terrain, and high-speed locomotion up to 37cm/s. Additionally, locomotion performance is compared to a hand-assembled quadruped with similar design parameters. The results demonstrate that the pop-up manufacturing methodology enables more complex mechanisms while simultaneously increasing performance over hand-assembled alternatives.Keywords
This publication has 20 references indexed in Scilit:
- Monolithic fabrication of millimeter-scale machinesJournal of Micromechanics and Microengineering, 2012
- Pop-up book MEMSJournal of Micromechanics and Microengineering, 2011
- Sensitive dependence of the motion of a legged robot on granular mediaProceedings of the National Academy of Sciences, 2009
- Microrobot Design Using Fiber Reinforced CompositesJournal of Mechanical Design, 2008
- Neuromechanical response of musculo-skeletal structures in cockroaches during rapid running on rough terrainJournal of Experimental Biology, 2008
- iSprawl: Design and Tuning for High-speed Autonomous Open-loop RunningThe International Journal of Robotics Research, 2006
- Dynamics of rapid vertical climbing in cockroaches reveals a templateJournal of Experimental Biology, 2006
- Optimal energy density piezoelectric bending actuatorsSensors and Actuators A: Physical, 2005
- Quantifying Dynamic Stability and Maneuverability in Legged LocomotionIntegrative and Comparative Biology, 2002
- RHex: A Simple and Highly Mobile Hexapod RobotThe International Journal of Robotics Research, 2001