Flows and heterogeneities with a vane tool: Magnetic resonance imaging measurements
Authors:
- Guillaume OvarlezGOGuillaume Ovarlez
- Fabien MahautFMFabien Mahaut
- François BertrandFBFrançois Bertrand
- Xavier ChateauXCXavier Chateau
- 1 March 2011
- journal article
- Published by Society of Rheology in Journal of Rheology
- Vol. 55 (2) , 197-223
Abstract
International audienceWe study the local flow properties of various materials in a vane-in-cup geometry. We use magnetic resonance imaging techniques to measure velocities and particle concentrations in flowing Newtonian fluid, yield stress fluid, and in a concentrated suspension of noncolloidal particles in a yield stress fluid. In the Newtonian fluid, we observe that the $\theta$-averaged strain rate component $d_{r,\theta}$ decreases as the inverse squared radius in the gap, in agreement with a Couette analogy. This allows direct comparison (without end-effect corrections) of the resistances to shear in vane and Couette geometries. Here, the mean shear stress in the vane-in-cup geometry is slightly lower than in a Couette cell of same dimensions, and a little higher than when the vane is embedded in an infinite medium. We also observe that the flow enters deeply the region between the blades, leading to significant extensional flow. In the yield stress fluid, in contrast with the usually accepted picture based on simulation results from the literature, we find that the layer of material that is sheared near the blades at low velocity is not cylindrical. There is thus a significant extensional component of shear that should be taken into account in the analysis. Finally and surprisingly, in the suspension, we observe that a thin non-cylindrical slip layer made of the pure interstitial yield stress fluid appears quickly at the interface between the sheared material and the material that moves as a rigid body between the blades. This feature can be attributed to the non-symmetric trajectories of the noncolloidal particles around the edges of the blades. This new important observation is in sharp contradiction with the common belief that the vane tool prevents slippage and may preclude the use of the vane tool for studying the flows of pasty materials with large particles
Keywords
All Related Versions
This publication has 57 references indexed in Scilit:
- Quantitative Analysis of Mixer‐Type Rheometers using the Couette AnalogyThe Canadian Journal of Chemical Engineering, 2002
- Vane Rheometry with a Large, Finite GapApplied Rheology, 2002
- Rotating vane rheometry — a reviewJournal of Non-Newtonian Fluid Mechanics, 2001
- Determination of shear rate and viscosity from batch mixer dataJournal of Rheology, 1999
- Microstructure of strongly sheared suspensions and its impact on rheology and diffusionJournal of Fluid Mechanics, 1997
- BINGHAM AWARD LECTURE—1994 Shear‐induced particle diffusion in concentrated suspensions of noncolloidal particlesJournal of Rheology, 1995
- The torque on a rotating n -bladed vane in a newtonian fluid or linear elastic mediumProceedings of the Royal Society of London. Series A: Mathematical and Physical Sciences, 1992
- Experimental observations of particle migration in concentrated suspensions: Couette flowJournal of Rheology, 1991
- Vane rheometry of bentonite gelsJournal of Non-Newtonian Fluid Mechanics, 1991
- The vane‐in‐cup as a novel rheometer geometry for shear thinning and thixotropic materialsJournal of Rheology, 1990