Color Determination from a Single Broadband Organic Photodiode
Open Access
- 9 February 2020
- journal article
- research article
- Published by Wiley in Advanced Optical Materials
- Vol. 8 (7)
Abstract
Establishing the color of incident light is essential for many applications, such as machine vision, but generally requires either a dispersive component or multiple spectrally selective photodetectors. In contrast, here an incident spectrum is parametrized using a single broadband organic photodiode (OPD). This is achieved by exploiting the incident wavelength dependence of charge extraction caused by optically induced trap states in a metal oxide electron extraction layer, which results in an atypical spectral dependence of the reverse bias photocurrent density vs voltage (J–V) characteristics. Such dependence is augmented by confining the active layer within an optical microcavity to influence the light absorption profile and thus metal oxide trap state density. The average wavelength of an (approximately normally distributed) incident spectrum is then calculated to within ≈5 nm by algorithmically minimizing the difference between a measured J–V curve and one determined from the overlap integral of a trial spectrum with previously acquired voltage bias dependent external quantum efficiency (EQE) spectra.Keywords
This publication has 77 references indexed in Scilit:
- Visualizing charge separation in bulk heterojunction organic solar cellsNature Communications, 2013
- From Binary to Ternary Solvent: Morphology Fine‐tuning of D/A Blends in PDPP3T‐based Polymer Solar CellsAdvanced Materials, 2012
- Light-Enhanced Bias Stress Effect on Amorphous In-Ga-Zn-O Thin-film Transistor with Lights of Varying ColorsElectrochemical and Solid-State Letters, 2011
- Probing Charge Carrier Density in a Layer of Photodoped ZnO Nanoparticles by Spectroscopic EllipsometryThe Journal of Physical Chemistry C, 2010
- Accounting for Interference, Scattering, and Electrode Absorption to Make Accurate Internal Quantum Efficiency Measurements in Organic and Other Thin Solar CellsAdvanced Materials, 2010
- Poly(diketopyrrolopyrrole−terthiophene) for Ambipolar Logic and PhotovoltaicsJournal of the American Chemical Society, 2009
- Subgap states in transparent amorphous oxide semiconductor, In–Ga–Zn–O, observed by bulk sensitive x-ray photoelectron spectroscopyApplied Physics Letters, 2008
- Electronic memory effects in diodes of zinc oxide nanoparticles in a matrix of polystyrene or poly(3-hexylthiophene)Journal of Applied Physics, 2007
- Study of field effect mobility in PCBM films and P3HT:PCBM blendsSolar Energy Materials and Solar Cells, 2005
- Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductorsNature, 2004