High Density RF-DC Plasma Nitriding under Optimized Conditions by Plasma-Diagnosis
Open Access
- 7 April 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (8) , 3706
Abstract
This paper is concerned with plasma diagnosis on a N2-H2 gas mixture to determine the optimum parameters for the nitriding process. Plasma parameters such as pressure, RF-voltage, and DC-bias were varied for optimization. The active species such as and NH were identified in plasma diagnosis. In the N2-H2 gas mixture, hydrogen imposed a great influence on plasma generation. The small addition of a hydrogen molecule into the gas mixture resulted in the highest yield of ions and NH radicals; the optimum hydrogen content was 20% in the mixture. The austenitic stainless-steel type AISI304 was nitrided at 673 K and 623 K to experimentally demonstrate that hydrogen gas content optimization is necessary to improve the surface hardness and to describe low temperature nitriding under high nitrogen flux at the surface.
Keywords
This publication has 19 references indexed in Scilit:
- Effect of pulse plasma nitriding on tribological properties of AISI 52100 and 440C steelsInternational Journal of Surface Science and Engineering, 2014
- S-phase surface engineering of Fe-Cr, Co-Cr and Ni-Cr alloysInternational Materials Reviews, 2010
- Recent developments in stainless steelsMaterials Science and Engineering: R: Reports, 2009
- Optical emission spectroscopy of DC pulsed plasmas used for steel nitridingSurface and Coatings Technology, 2008
- Molecular dissociation in N2–H2 microwave dischargesPlasma Sources Science and Technology, 2004
- Surface engineering of austenitic stainless steelSurface Engineering, 2002
- Investigation on the pulsed DC plasma nitriding with optical emission spectroscopySurface and Coatings Technology, 2002
- Low-temperature plasma-assisted nitridingSurface and Coatings Technology, 2000
- The role of hydrogen in plasma nitriding: Hydrogen behavior in the titanium nitride layerPlasmas & Ions, 2000
- Active species in microwave postdischarge for steel-surface nitridingIEEE Transactions on Plasma Science, 1990