An Eight-Channel 15–55 GHz Dual-Beam Receive Phased-Array Beamformer IC With 2.9–4.2 dB NF for Multiband 5G Operation
- 26 July 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 73 (1) , 661-673
Abstract
This article presents a 15–55-GHz multiband dual-beam receive phased-array to cover the fifth-generation (5G) new radio (NR) frequency range 2 (FR2) bands. The phased array is based on an eight-channel ( $4\ttimes2$ ) dual-beam receive beamformer chip which is designed in a SiGe BiCMOS process. The chip adopts RF beamforming with differential RF inputs to interface with wideband differential Vivaldi antennas. Each channel pair consists of a low noise amplifier (LNA) that splits the power between two channels each with a phase shifter (PS), a variable gain amplifier (VGA), and a differential-to-single-ended stage (D2S). Two 4:1 Wilkinson (WK) combining networks are used to combine the outputs of the eight channels into two independent RF outputs. The beamformer chip results in an electronic gain of 24–30 dB with 2.9–4.2-dB noise figure (NF) and $-$ 31 $\pm$ 3 dBm input power 1-dB compression point (IP1dB) at 15–50 GHz and consumes 185 mW/channel. A 16-element phased array module is built on a printed circuit board (PCB) using beamformer chips and scans up to $\pm$ 60 $^\circ$ with side lobes below $-$ 11 dB across multiple 5G FR2 bands. A wireless link is demonstrated with 12-Gb/s data rates using 64-QAM single carrier signals and $<$ 2.62% error vector magnitude (EVM) with 400-MHz orthogonal frequency-division multiplexing (OFDM) 5G NR signals. To the authors’ knowledge, this work achieves the lowest noise figure among wideband designs covering the 5G FR2 spectrum.Keywords
Funding Information
- CACI-LGS
This publication has 22 references indexed in Scilit:
- A Wideband Ultra-Low Noise 15–55 GHz Dual-Beam Receive Phased-Array Beamformer with 2.9-4.2 dB NF2023
- A 28-GHz CMOS Phased-Array Beamformer Utilizing Neutralized Bi-Directional Technique Supporting Dual-Polarized MIMO for 5G NRIEEE Journal of Solid-State Circuits, 2020
- A 39-GHz 64-Element Phased-Array Transceiver With Built-In Phase and Amplitude Calibrations for Large-Array 5G NR in 65-nm CMOSIEEE Journal of Solid-State Circuits, 2020
- A 24.5–43.5-GHz Ultra-Compact CMOS Receiver Front End With Calibration-Free Instantaneous Full-Band Image Rejection for Multiband 5G Massive MIMOIEEE Journal of Solid-State Circuits, 2020
- A Reconfigurable 28-/37-GHz MMSE-Adaptive Hybrid-Beamforming Receiver for Carrier Aggregation and Multi-Standard MIMO CommunicationIEEE Journal of Solid-State Circuits, 2019
- A Low-Cost Scalable 32-Element 28-GHz Phased Array Transceiver for 5G Communication Links Based on a $2\times 2$ Beamformer Flip-Chip Unit CellIEEE Journal of Solid-State Circuits, 2018
- A 28-GHz 32-Element TRX Phased-Array IC With Concurrent Dual-Polarized Operation and Orthogonal Phase and Gain Control for 5G CommunicationsIEEE Journal of Solid-State Circuits, 2017
- On the Design of Wideband Transformer-Based Fourth Order Matching Networks for ${E}$ -Band Receivers in 28-nm CMOSIEEE Journal of Solid-State Circuits, 2017
- A Wideband Receiver for Multi-Gbit/s Communications in 65 nm CMOSIEEE Journal of Solid-State Circuits, 2011
- 0.13-$\mu$m CMOS Phase Shifters for X-, Ku-, and K-Band Phased ArraysIEEE Journal of Solid-State Circuits, 2007