Preparation of polyethylene–octene elastomer foams by compression molding
Authors:
- 23 May 2008
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 109 (5) , 3249-3255
Abstract
To produce polyethylene–octene elastomer foams with compression molding, the influences of various activators on the thermal decomposition temperature of the chemical blowing agent azodicarbonamide were investigated with thermogravimetric analysis, which showed that the decomposition temperature of azodicarbonamide could be effectively reduced by the addition of zinc oxide/zinc stearate. The results of a moving die rheometer suggested that the vulcanization and blowing curves were influenced by the content of azodicarbonamide and temperature, and the optimum temperature was about 170°C. The morphology and physical properties of the microcellular polyethylene–octene elastomer were studied. The results indicated that the amount of azodicarbonamide and the processing temperature played important roles in the cell morphology and physical properties of polyethylene–octene elastomer foams. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci 2008Keywords
This publication has 19 references indexed in Scilit:
- DSC study of transitions involved in thermal treatment of foamable mixtures of PE and EVA copolymer with azodicarbonamideJournal of Applied Polymer Science, 2006
- Effect of long‐chain branches of polypropylene on rheological properties and foam‐extrusion performancesJournal of Applied Polymer Science, 2005
- Physical properties of ethylene vinyl acetate copolymer (EVA)/natural rubber (NR) blend based foamJournal of Applied Polymer Science, 2004
- Compatibilization and toughening of poly(2,6‐dimethyl‐1,4‐phenylene oxide)/polyamide 6 alloy with poly(ethylene 1‐octene): Mechanical properties, morphology, and rheologyJournal of Applied Polymer Science, 2003
- Evaluation of rheological and mechanical behavior of blends based on polypropylene and metallocene elastomersPolymer Testing, 2002
- Modeling Foam Growth in ThermoplasticsAdvanced Materials, 2000
- Production of low‐density LLDPE foams in rotational moldingPolymer Engineering & Science, 1998
- Influence of interfacial adhesion on toughening of polyethylene-octene elastomer/nylon 6 blendsJournal of Applied Polymer Science, 1998
- Polymeric Foams: An Overview1997
- Low density cellular plastics1994