Low Voltage CO$_2$-Gas Sensor Based on III–V Mid-IR Immersion Lens Diode Optopairs: Where we Are and How Far we Can Go?
- 28 December 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 10 (2) , 225-234
Abstract
This study presents a comparative analysis of parameters of infrared radiation source and detector hardware that are most important for the creation of portable optical nondispersive infrared (NDIR) gas sensors. An analytical model of the optical gas sensor is proposed. The notions of an instrument and transfer functions of the sensor as a measurement device are introduced. Capabilities of the model have been demonstrated by the example of carbon dioxide sensor based on immersion diode optopairs. Validity of the model is proved by good coincidence of calculated and experimental data. Analytical description of the transfer function of a NDIR carbon dioxide sensor allowed us to carry out the comparative analysis of potential sensitivity of sensors based on different hardware produced by basic fabricators of IR components.Keywords
This publication has 8 references indexed in Scilit:
- Room-temperature broadband InAsSb flip-chip photodiodes with λcut off = 4.5 μmSemiconductors, 2009
- Modeling of performance of mid-infrared gas sensors based on immersion lens diode optopairs2008
- Micromachined mid-infrared emitter for fast transient temperature operation for optical gas sensing systems2008
- InAs and InAs(Sb)(P) (3-5 μm) immersion lens photodiodes for portable optic sensors2007
- LED-Photodiode Opto-pairs2006
- Gas-Phase Databases for Quantitative Infrared SpectroscopyApplied Spectroscopy, 2004
- Low voltage episide down bonded mid-IR diode optopairs for gas sensing in the 3.3–4.3 μm spectral rangeSensors and Actuators B: Chemical, 2003
- Recent developments in the applications of mid-infrared lasers, LEDs, and other solid state sources to gas detection2002