Electrospun polymeric nanohybrids with outstanding pollutants adsorption and electroactivity for water treatment and sensing devices
Authors:
Open Access
- 15 January 2024
- journal article
- research article
- Published by Springer Nature in Advanced Composites and Hybrid Materials
- Vol. 7 (1) , 1-19
Abstract
Graphene oxide (GO) and carbon nanotubes (CNTs) were loaded at different mutual ratios into poly(vinylidene fluoride-co-hexafluoropropylene) (PVDF-co-HFP) matrix and electrospun to construct mats that were assessed as smart sorbents for decontaminating water from methylene blue (MB) pollutant, while ensuring the additional possibility of detecting the dye amounts. The results revealed that sorption capacity enhances upon increasing GO content, which is beneficial to wettability and active area. Equilibrium adsorption of these materials is precisely predicted by the Langmuir isotherm model and the maximum capacities herein achieved, ranging from 120 to 555 mg/g depending on the formulation, are higher than those reported for similar systems. The evolution of the structure and properties of such materials as a function of dye adsorption was studied. The results reveal that MB molecules prompted the increase of electrical conductivity of the samples in a dose-dependent manner. Mats containing solely CNTs, while displaying the worst sorption performance, showed the highest electrical performances, displaying interesting changes in their electrical response as a function of the dye amount adsorbed, with a linear response and high sensitivity (309.4 µS cm−1 mg−1) in the range 0–235 µg of dye adsorbed. Beyond the possibility to monitor the presence of small amounts of MB in contaminated water and the saturation state of sorbents, this feature could even be exploited to transform waste sorbents into high-added value products, including flexible sensors for detecting low values of pressure, human motion, and so on. Graphical Abstract Multifunctional materials for dye absorption and detection, pressure sensing, fabricated by integrating GO and CNTs into PVDF-HFP matrix via electrospinning.Keywords
Funding Information
- European Commission (PE00000004, PE00000004)
- Università degli Studi di Palermo
This publication has 64 references indexed in Scilit:
- Effect of pressure on the structure and properties of polymeric gel based on polymer PVdF-HFP and ionic liquid [BMIM][BF4]Colloid and Polymer Science, 2014
- Self‐Assembly of Graphene Oxide at InterfacesAdvanced Materials, 2014
- Statistical Study of the Influence of CNTs Purification and Plasma Functionalization on the Properties of Polycarbonate-CNTs NanocompositesPlasma Processes and Polymers, 2014
- Graphene oxide dispersions: tuning rheology to enable fabricationMaterials Horizons, 2014
- Graphene oxide functionalized with methylene blue and its performance in singlet oxygen generationMaterials Research Bulletin, 2013
- Structural changes in PVDF fibers due to electrospinning and its effect on biological functionBiomedical Materials, 2013
- High performance PA6/CNTs nanohybrid fibers prepared in the meltComposites Science and Technology, 2012
- Graphene Oxide: Surface Activity and Two‐Dimensional AssemblyAdvanced Materials, 2010
- Initial behavior of intraparticle diffusion model used in the description of adsorption kineticsChemical Engineering Journal, 2009
- Current–voltage and capacitance–voltage characteristics of a Sn/Methylene Blue/p-Si Schottky diodeSynthetic Metals, 2009