Concept for a MEMS-type vacuum sensor based on electrical conductivity measurements
Open Access
- 16 November 2017
- journal article
- Published by Copernicus GmbH in Journal of Sensors and Sensor Systems
- Vol. 6 (2) , 367-374
Abstract
The concept of the micro-structured vacuum sensor presented in this article is the measurement of the electrical conductivity of thinned gases in order to develop a small, economical and quite a simple type of vacuum sensor. There are already some approaches for small vacuum sensors. Most of them are based on conservative measurement principles similar to those used in macroscopic vacuum gauges. Ionization gauges use additional sources of energy, like hot cathodes, ultraviolet radiation or high voltage for example, for ionizing gas molecules and thereby increasing the number of charge carriers for measuring low pressures. In contrast, the concept discussed here cannot be found in macroscopic sensor systems because it depends on the microscopic dimension of a gas volume defined by two electrodes. Here we present the concept and the production of a micro-structured vacuum sensor chip, followed by the electrical characterization. Reference measurements with electrodes at a distance of about 1 mm showed currents in the size of picoampere and a conductivity depending on ambient pressure. In comparison with these preliminary measurements, fundamental differences regarding pressure dependence of the conductivity are monitored in the electrical characterization of the micro-structured sensor chip. Finally the future perspectives of this sensor concept are discussed.Keywords
This publication has 17 references indexed in Scilit:
- Influence of humidity and air pressure on the ion mobility based on drift tube methodCSEE Journal of Power and Energy Systems, 2015
- Design, simulation, fabrication and characterization of nano-scaled acceleration gridsMicroelectronic Engineering, 2014
- Intelligent thermal vacuum sensors based on multipurpose thermopile MEMS chipsVacuum, 2014
- A wide measurement pressure range CMOS-MEMS based integrated thermopile vacuum gauge with an XeF2 dry-etching processSensors and Actuators A: Physical, 2013
- Extension of Operating Range Towards Lower Pressures of MEMS-based Thermal Vacuum Gauges by Laser-Induced HeatingProcedia Engineering, 2012
- Miniature and MEMS-type vacuum sensors and pumpsVacuum, 2009
- Cross Sections for Electron Collisions with Oxygen MoleculesJournal of Physical and Chemical Reference Data, 2008
- A MEMS friction vacuum gauge suitable for high temperature environmentSensors and Actuators A: Physical, 2008
- Microstructured vacuum gauges and their future perspectivesVacuum, 2007
- Cross Sections for Collisions of Electrons and Photons with Nitrogen MoleculesJournal of Physical and Chemical Reference Data, 1986