Characterization of Sand and Dust Pollution Degradation Based on Sensitive Structure of Microelectromechanical System Flow Sensor
Open Access
- 26 April 2024
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 15 (5) , 574
Abstract
The effect of sand and dust pollution on the sensitive structures of flow sensors in microelectromechanical systems (MEMS) is a hot issue in current MEMS reliability research. However, previous studies on sand and dust contamination have only searched for sensor accuracy degradation due to heat conduction in sand and dust cover and have yet to search for other failure-inducing factors. This paper aims to discover the other inducing factors for the accuracy failure of MEMS flow sensors under sand and dust pollution by using a combined model simulation and sample test method. The accuracy of a flow sensor is mainly reflected by the size of its thermistor, so in this study, the output value of the thermistor value was chosen as an electrical characterization parameter to verify the change in the sensor’s accuracy side by side. The results show that after excluding the influence of heat conduction, when sand particles fall on the device, the mutual friction between the sand particles will produce an electrostatic current; through the principle of electrostatic dissipation into the thermistor, the principle of measurement leads to the resistance value becoming smaller, and when the sand dust is stationary for some time, the resistance value returns to the expected level. This finding provides theoretical guidance for finding failure-inducing factors in MEMS failure modes.Keywords
Funding Information
- National Key R&D Program of China (2020YFB2008900, 62104047, 2023A1515010291, 2023A04J1707)
- National Natural Science Foundation of China (2020YFB2008900, 62104047, 2023A1515010291, 2023A04J1707)
- Guangdong Basic and Applied Basic Research Foundation (2020YFB2008900, 62104047, 2023A1515010291, 2023A04J1707)
- Basic and Applied Basic Research Foundation of Guangzhou Basic Research Program (2020YFB2008900, 62104047, 2023A1515010291, 2023A04J1707)
This publication has 16 references indexed in Scilit:
- Particulate Matter in the American Southwest: Detection and Analysis of Dust Storms Using Surface Measurements and Ground-Based LIDARAtmosphere, 2024
- Water Flow Boiling in Micro/Mini Channels Using Volume of Fluid ModelApplied Sciences, 2024
- Application of the Euler–Lagrange Approach and Immersed Boundary Method to Investigate the Behavior of Rigid Particles in a Confined FlowAxioms, 2023
- A particle deposition model considering particle size distribution based on the Eulerian approachPowder Technology, 2023
- Advances in Triboelectric Flow SensorAdvanced Materials Technologies, 2023
- Effect of {010} crystal facets of Bi2MoO6 and 1D/2D heterostructures for conductometric room temperature NH3 gas sensorsSensors and Actuators B: Chemical, 2022
- Investigation of deposition characteristics on tube-bundle heat exchanger with an improved ash particle modelPowder Technology, 2022
- Gas flow influences on bubbling and flow characteristics of fluidized bed with immersed tube under electrostatic effectsAdvanced Powder Technology, 2022
- Characteristic analysis of a capacitive pressure-sensitive structure with linkage filmJournal of Computational Electronics, 2021
- A sublayer model for turbulent deposition of particles in vertical ducts with smooth and rough surfacesJournal of Aerosol Science, 1993