VHCF Response up to 109 Cycles of SLM AlSi10Mg Specimens Built in a Vertical Direction
Open Access
- 24 July 2019
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 9 (15) , 2954
Abstract
It is well-known that many manufacturing parameters affect the quasi-static and the fatigue response of additive manufacturing (AM) parts. In particular, due to the layer-by-layer production, the load orientation, with respect to the building direction, plays a fundamental role for the fatigue response. This paper investigates the fatigue response up to 109 cycles (very high cycle fatigue (VHCF)) of selective laser melting (SLM) AlSi10Mg specimens built in a vertical direction. Ultrasonic tension-compression tests (stress ratio of –1) are carried out on as-built Gaussian specimens with a large loaded volume (2300 mm3). Fracture surfaces are investigated with the scanning electron microscope to analyze the defects originating the VHCF failure. Probabilistic S-N curves are estimated and analyzed. Experimental results confirm that the defect size controls the VHCF response, thus highlighting the importance of testing large risk volumes for a reliable assessment of VHCF behavior. The average value of the VHCF strength is close to that of the hourglass specimen tested in the literature. The variability of the VHCF strength is instead significantly larger, due to the scattered size distribution of the defects located near the specimen surface, which is the most critical region for crack initiation.Keywords
This publication has 37 references indexed in Scilit:
- A survey on mechanisms and critical parameters on solidification of selective laser melting during fabrication of Ti-6Al-4V prosthetic acetabular cupMaterials & Design, 2016
- The microstructure and mechanical properties of selectively laser melted AlSi10Mg: The effect of a conventional T6-like heat treatmentMaterials Science and Engineering: A, 2016
- S‐N curves in the very‐high‐cycle fatigue regime: statistical modeling based on the hydrogen embrittlement considerationFatigue & Fracture of Engineering Materials & Structures, 2016
- Additive manufacturing of heat exchangers: A case study on a multi-layered Ti–6Al–4V oscillating heat pipeAdditive Manufacturing, 2015
- A review on selective laser sintering/melting (SLS/SLM) of aluminium alloy powders: Processing, microstructure, and propertiesProgress in Materials Science, 2015
- Influence of process-induced microstructure and imperfections on mechanical properties of AlSi12 processed by selective laser meltingJournal of Materials Processing Technology, 2015
- VHCF Response of AISI H13 Steel: assessment of Size Effects through Gaussian SpecimensProcedia Engineering, 2015
- Reducing porosity in AlSi10Mg parts processed by selective laser meltingAdditive Manufacturing, 2014
- On specimen design for size effect evaluation in ultrasonic gigacycle fatigue testingFatigue & Fracture of Engineering Materials & Structures, 2014
- Additive manufactured AlSi10Mg samples using Selective Laser Melting (SLM): Microstructure, high cycle fatigue, and fracture behaviorMaterials & Design (1980-2015), 2012