An Assessment of Refrigerant Heat Transfer, Pressure Drop, and Void Fraction Effects In Microfin Tubes
Authors:
- 1 April 2001
- journal article
- research article
- Published by Taylor & Francis in HVAC&R Research
- Vol. 7 (2) , 125-153
Abstract
Microfin tubing can significantly increase heat transfer in refrigeration evaporators and condensers. The effectiveness of microfins is dependent on fluid properties, flow field configuration, heat flux direction (evaporation and condensation), and tube geometry. This review focuses on the performance of microfin tubes in refrigeration systems and details information known about microfin tube performance as well as information that is not yet investigated. Generally, microfins enhance heat transfer by an amount that is similar or greater than the amount of surface area added to the internal wall surface. Pressure drop does not tend to increase significantly; however, the range of reported pressure drop effects is broad. Oil generally degrades heat transfer and increases pressure drop; however, the oil concentration and viscosity are important factors.Keywords
This publication has 33 references indexed in Scilit:
- Heat transfer and pressure drop during condensation of refrigerants inside horizontal enhanced tubesInternational Journal of Refrigeration, 2000
- Heat transfer and pressure drop during condensation of refrigerant 134a in an axially grooved tubeInternational Journal of Heat and Mass Transfer, 1999
- Boiling of new refrigerants: a state-of-the-art reviewInternational Journal of Refrigeration, 1996
- Horizontal flow boiling of R22 and R407C in a 9.52 mm micro-fin tubeApplied Thermal Engineering, 1996
- Advanced micro-fin tubes for condensationInternational Journal of Heat and Mass Transfer, 1996
- Advanced micro-fin tubes for evaporationInternational Journal of Heat and Mass Transfer, 1996
- Condensation of R-12 in small hydraulic diameter extruded aluminum tubes with and without micro-finsInternational Journal of Heat and Mass Transfer, 1996
- Friction pressure drop of R-12 in small hydraulic diameter extruded aluminum tubes with and without micro-finsInternational Journal of Heat and Mass Transfer, 1996
- Condensation heat transfer of binary refrigerant mixtures of R22 and R114 inside a horizontal tube with internal spiral groovesInternational Journal of Refrigeration, 1990
- A general correlation for heat transfer during film condensation inside pipesInternational Journal of Heat and Mass Transfer, 1979