Conducting bicomponent fibers obtained by melt spinning of PA6 and polyolefins containing high amounts of carbonaceous fillers
Authors:
- 9 August 2011
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 123 (2) , 936-943
Abstract
Melt spinning of conductive polymer composites (CPCs) is coupled with some difficulties such as a decrease of conductivity upon drawing and a reduced spinnability with increasing filler concentration. Applying bicomponent technology may provide the possibility to produce fibers from CPCs with a high filler concentration. A pilot‐scale bicomponent melt spinning set‐up was used to produce core/sheath fibers with fiber titers between 13 and 47 dtex. The sheath material was polyamide 6 (PA6) or polypropylene (PP) and the core material was a CPC. Two CPCs were used, polypropylene (PP) with carbon black (CB), denoted by PP/CB, and polyethylene (PE) with multiwalled carbon nanotubes (MWNT), denoted by PE/MWNT. The results showed that both materials could be used with a filler concentration of 10 wt % to obtain melt draw ratios up to 195. The volumetric fraction of core material in the bicomponent structure was 28%. A heat treatment of PP/CB fibers restored the conductivity to the level of the undrawn material, corresponding to an increase in conductivity by a factor 5. The same heat treatment had a positive effect on the conductivity of PE/MWNT fibers although the conductivity was not restored. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2011Keywords
This publication has 14 references indexed in Scilit:
- Melt spinning of conducting polymeric composites containing carbonaceous fillersJournal of Applied Polymer Science, 2010
- Liquid sensing properties of fibres prepared by melt spinning from poly(lactic acid) containing multi-walled carbon nanotubesComposites Science and Technology, 2010
- Destruction and formation of a carbon nanotube network in polymer melts: Rheology and conductivity spectroscopyPolymer, 2008
- Conductive polymer composites with double percolated architecture of carbon nanoparticles and ceramic microparticles for high heat dissipation and sharp PTC switchingSmart Materials and Structures, 2008
- Effects of the addition of multi-walled carbon nanotubes on the positive temperature coefficient characteristics of carbon-black-filled high-density polyethylene nanocompositesScripta Materialia, 2006
- Orientation of multiwalled carbon nanotubes in composites with polycarbonate by melt spinningPolymer, 2005
- Modification of fiber-forming polymers by additivesProgress in Polymer Science, 2002
- Aligned single-wall carbon nanotubes in composites by melt processing methodsChemical Physics Letters, 2000
- Electrical properties of composites in the vicinity of the percolation thresholdJournal of Applied Polymer Science, 1999
- Kinetic and Thermodynamic Control of the Selective Localization of Carbon Black at the Interface of Immiscible Polymer BlendsChemistry of Materials, 1998