Direct and rapid determination of ultratrace heavy metals in solid plant materials by ET‐AAS ultrasonic‐assisted slurry sampling
- 11 June 2010
- journal article
- research article
- Published by Wiley in Phytochemical Analysis
- Vol. 21 (4) , 340-347
Abstract
Introduction – Plants can be used as bioindicators in the study of contamination processes by heavy metals. Most of the analytical methodologies used for determination of metals in plants are based on atomic techniques with previous wet digestion of the solid samples. Methodologies that allow direct metal measurements in solid samples are very attractive alternatives.Objective – To develop a new procedure for direct analysis of copper, nickel, cadmium and lead at very low concentration levels in leaves based on electrothermal atomic absorption spectroscopy (ET‐AAS) with introduction of samples as a slurry.Methodology – In order to obtain accurate and precise results even at very low concentrations, the different parameters that influence the sample slurry preparation such as acid percentage, presence of stabilising agents and ultrasonic probe operation were studied. Instrumental parameters such as chemical modifier and temperature and times for drying, pyrolysis and atomisation steps that influence ET‐AAS measurement were optimised.Results – Optimal slurry conditions for copper and nickel determination were 0.5% Tween 85 with 5% nitric acid. For lead and cadmium analysis the best results were obtained in 5% nitric acid without stabilising agents. The achieved detection limits were 0.023 mg/kg for copper, 0.018 mg/kg for nickel, 0.0002 mg/kg for cadmium and 0.009 mg/kg for lead. For validation purposes, the method was applied to metal analysis in a pine needles reference material.Conclusion – According to our knowledge, the detection limits obtained are the best reported in the literature. The methodology was successfully used in metal determinations in actual leaf samples. Copyright © 2010 John Wiley & Sons, Ltd.Keywords
This publication has 24 references indexed in Scilit:
- Contribution to biomonitoring of some trace metals by deciduous tree leaves in urban areasEnvironmental Monitoring and Assessment, 2007
- Development of an ultrasound-assisted extraction method for biomonitoring of vanadium and nickel in the coastal environment under the influence of the Prestige fuel spill (North east Atlantic Ocean)Analytica Chimica Acta, 2006
- Current Status of Direct Solid Sampling for Electrothermal Atomic Absorption Spectrometry—A Critical Review of the Development between 1995 and 2005Applied Spectroscopy Reviews, 2006
- Determination of chromium by GFAAS in slurries of fish feces to estimate the apparent digestibility of nutrients in feed used in piscicultureTalanta, 2006
- Determination of Cd and Pb in biological reference materials by electrothermal atomic absorption spectrometry: A comparison of three ultrasonic-based sample treatment proceduresTalanta, 2006
- Determination of lead and cadmium by atomic absorption spectrometry coupled with slurry sampling of carbonized samples: Use of palladium-bearing activated carbon as a matrix modifierJournal of Analytical Chemistry, 2006
- Effect of modifiers on thermal behaviour of Se in acid digestates and slurries of vegetables by graphite furnace atomic absorption spectrometryFood Chemistry, 2002
- Slurry sampling for direct analysis of solid materials by electrothermal atomic absorption spectrometry (ETAAS). A literature review from 1990 to 2000Talanta, 2002
- Slurry sampling graphite furnace atomic absorption spectrometry: a preliminary examination of results from an international collaborative studySpectrochimica Acta Part B: Atomic Spectroscopy, 1995
- Influence of slurry preparation on the accuracy of ultrasonic slurry electrothermal atomic absorption spectrometryJournal of Analytical Atomic Spectrometry, 1994