Optimal Material Properties of Molding Compounds for MEMS Package
Authors:
- 8 September 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 4 (10) , 1589-1597
Abstract
In this paper, an optimization study of molding compounds for a microelectromechanical systems (MEMS) sensor package has been performed. A comprehensive finite element analysis model was established for the MEMS sensor package to assess the stresses and deformations when the package was subjected to temperature loading. A series of stress relaxation tests were performed to characterize the viscoelastic material properties of a molding compound over temperature with dynamic mechanical analysis. A master curve for the molding compound was constructed by a proper shift function and the Prony pairs were obtained by curve fitting to be implemented in the simulation. To validate the simulation result, the thermal behavior of the MEMS package was measured. The digital image correlation technique was employed to observe the real-time deformation of the package exposed to temperature loading. The out-of-plane deformation of the package was compared with the simulation result. With the validated simulation model, the optimization study was conducted. By the process simulation, it has been shown that most of the thermal stress on the MEMS sensor chip was generated during the cooling process. Thus, a detailed cooling profile was developed by the transient heat analysis and applied to the parametric study. The modulus, coefficient of thermal expansion (CTE), and glass transition temperature (Tg) of molding compound were investigated. The result shows that a low modulus, low CTE, and low Tg molding compound can minimize the thermal stress on MEMS sensor die.Keywords
This publication has 12 references indexed in Scilit:
- Stress evolution in an encapsulated MEMS package due to viscoelasticity of packaging materials2012
- Characterization of the Viscoelasticity of Molding Compounds in the Time DomainJournal of Electronic Materials, 2010
- On the Way to Zero Defect of Plastic-Encapsulated Electronic Power Devices—Part II: Molding CompoundIEEE Transactions on Device and Materials Reliability, 2009
- Estimating the Engineering Properties of Electronic Packaging MaterialsIEEE Transactions on Components and Packaging Technologies, 2008
- Packaging Effect on MEMS Pressure Sensor PerformanceIEEE Transactions on Components and Packaging Technologies, 2007
- The Effect of Epoxy Molding Compound on Thermal/Residual Deformations and Stresses in IC Packages During Manufacturing ProcessIEEE Transactions on Components and Packaging Technologies, 2006
- Warpage analysis of epoxy molded packages using viscoelastic based modelJournal of Materials Science, 2006
- Finite element simulation of package stress in transfer molded MEMS pressure sensorsMicroelectronics Reliability, 2004
- Chemical shrinkage and diffusion-controlled reaction of an epoxy molding compoundEuropean Polymer Journal, 2000
- Characterization of chip scale packaging materialsMicroelectronics Reliability, 1999