Fabrication of High Precision PEMFC Membrane Electrode Assemblies by Sieve Printing Method
- 3 March 2009
- journal article
- Published by ASME International in Journal of Fuel Cell Science and Technology
- Vol. 6 (2) , 021305
Abstract
A sieve printing technique has been developed for the preparation of gas diffusion electrodes for proton exchange membrane fuel cells (PEMFCs). The results of the preparation of membrane electrode assemblies (MEAs) are shown to be faster and highly reproducible by using the sieve printing and hot pressing method. These results were compared with those obtained by spray and hot pressing method. The experiments were carried out in a single PEM fuel cell with platinum loadings of and on the anode and cathode, respectively. Scanning electron microscopy analysis was used to investigate the electrodes’ morphology. The performance of the MEAs was measured by polarization curves. It was observed that the sieve printing technique is highly reproducible and significantly more accurate and faster than the spray one. Sieve printing technique can be easily scaled up and is very adequate for high volume production with low-cost. Such features allow manufacturing large active areas for power stack fabrication. In addition, this deposition technique has produced MEAs with a 39.8% higher power density at 0.6 V when compared with the spray one.
Keywords
This publication has 8 references indexed in Scilit:
- Novel method for preparation of PEMFC electrodes by the electrospray techniqueJournal of Power Sources, 2005
- Effects of membrane electrode assembly preparation on the polymer electrolyte membrane fuel cell performanceElectrochimica Acta, 2004
- PEM fuel cell electrodesJournal of Power Sources, 2004
- Fabrication of high precision PEFC membrane electrode assembliesJournal of Power Sources, 2003
- Targeting improved DMFC performanceJournal of Power Sources, 2002
- Innovative production procedure for low cost PEFC electrodes and electrode/membrane structuresInternational Journal of Hydrogen Energy, 1998
- Development and electrochemical studies of gas diffusion electrodes for polymer electrolyte fuel cellsJournal of Applied Electrochemistry, 1996
- High performance electrodes with very low platinum loading for polymer electrolyte fuel cellsElectrochimica Acta, 1995