Comparison of the mechanical and wear behaviour of aluminium alloy with homogeneous and functionally graded silicon nitride composites
Author:
Open Access
- 14 September 2016
- journal article
- research article
- Published by Walter de Gruyter GmbH in Science and Engineering of Composite Materials
- Vol. 25 (2) , 261-271
Abstract
Homogeneous and functionally graded LM25 aluminium (Al) composites were fabricated by incorporating silicon nitride (10 wt%, 40 µm) particles through liquid metallurgy and centrifugal casting, respectively. The performance of these composites was compared with unreinforced alloy. The microstructural behaviour of the surfaces of unreinforced alloy, homogeneous composite and functionally graded composite (outer, middle and inner surfaces) were examined through optical microscopy. These surfaces were also evaluated for mechanical properties. An abrasive wear test was conducted on all these surfaces to determine their effect on wear rate. The microstructural results revealed a particle-rich region at the outer surface of the functionally graded composite material and uniform dispersion of reinforcement particles in the homogeneous composite. The outer region of the functionally graded composite showed greater hardness and the homogeneous composite displayed higher tensile strength. The abrasive wear rate increased with an increase in load and decreased with an increase in speed, and the particle-rich outer surface showed a lower wear rate. Scanning electron microscopy analysis revealed a particle-rich outer surface of functionally graded composite with fewer scratches. Therefore, higher wear resistance was observed at the outer periphery of functionally graded composites and this property can be well-utilised in automotive tribo-components such as in cylinder liners for improved performance.Keywords
This publication has 17 references indexed in Scilit:
- Development of light weight ALFA compositesInternational Journal of Engineering, Science and Technology, 2011
- Dry sliding wear of Al alloy/SiCp functionally graded composites: Influence of processing conditionsWear, 2009
- Advantages of the centrifugal casting technique for the production of structural components with Al–Si alloysMaterials & Design (1980-2015), 2008
- A model for the abrasive wear behaviour of aluminium based compositesMaterials & Design (1980-2015), 2008
- Application of Taguchi techniques to study dry sliding wear behaviour of metal matrix compositesMaterials & Design (1980-2015), 2007
- Abrasive wear of Al2O3 particle reinforced 2024 aluminium alloy composites fabricated by vortex methodComposites Part A: Applied Science and Manufacturing, 2006
- Functionally graded aluminum matrix composites produced by centrifugal castingMaterials Characterization, 2005
- Effect of Al2O3 Particles on the Microstructure and Sliding Wear of 7075 Al Alloy Manufactured by Squeeze Casting MethodJournal of Materials Engineering and Performance, 2004
- Microstructure and mechanical behavior of functionally graded Al A359/SiCp compositeMaterials Science and Engineering: A, 2002
- Three-body abrasion of Al–SiC compositesWear, 1999