A 440-nA True Random Number Generator for Passive RFID Tags
Authors:
- 17 June 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 55 (11) , 3723-3732
Abstract
This paper describes a 440-nA true random number (RN) generator for passive ultrahigh frequency radio frequency identification (RFID) tags that operate in the 900-MHz band. Since passive tags derive their power supply through the rectification of the incoming RF signal, limited power is available, and hence, a typical total IC current budget is less than a few microamperes. An RN is generated by a passive RFID tag on the fly, and it is used by the reader to identify the tag uniquely and communicate with it in a field consisting of many tags. The RN in this paper consists of a 16-bit-long deterministic binary sequence to which a 3-bit true RN is added. Without the 3-bit true RN, if two tags happen to have the same deterministic 16-bit sequence, a collision occurs, and there is no way to resolve it. In this paper, we propose a power efficient way of generating the 3-bit true RN using the jitter-sampled carrier technique. This technique subsamples the already present 900-MHz RF carrier using a jittered (noisy) clock. The design challenges of sampling a high-frequency signal that swings above and below ground are described. In addition, the generation of a jitter of adequate magnitude with adequate high-frequency spectral content to ensure that the number is truly random is also described. Measurement results on a silicon prototype implemented in a 130-nm analog CMOS process are provided.Keywords
This publication has 18 references indexed in Scilit:
- True Random Number Generator With a Metastability-Based Quality ControlIEEE Journal of Solid-State Circuits, 2008
- A Passive UHF RFID Transponder for EPC Gen 2 with -14dBm Sensitivity in 0.13μm CMOS2007
- A 2.92μW Hardware Random Number Generator2006
- Cross-coupled chaotic oscillators and application to random bit generationIEE Proceedings - Circuits, Devices and Systems, 2006
- Switched-current 3-bit CMOS 4.0-MHz wideband random signal generatorIEEE Journal of Solid-State Circuits, 2005
- Design of ultra-low-cost UHF RFID tags for supply chain applicationsIEEE Communications Magazine, 2004
- Physical random number generator based on MOS structure after soft breakdownIEEE Journal of Solid-State Circuits, 2004
- An integrated analog/digital random noise sourceIEEE Transactions on Circuits and Systems I: Regular Papers, 1997
- Modeling and simulation of oscillator-based random number generators1996
- Nonlinear switched-current CMOS IC for random signal generationElectronics Letters, 1993