Influence of Interlayers on Adhesion Strength of TiN Film on Mg Alloy
Open Access
Abstract
The wide application of Mg alloys has been restricted because of their poor corrosion and wear resistance. Titanium nitride ceramic films prepared via magnetron sputtering can improve the corrosion and wear resistance of Mg alloys. However, residual stress produced at the interface between the film and the Mg alloy substrate causes the TiN film to spall off and reduces its service life. One potential approach to mitigating residual stress involves enhancing the adhesive strength between the film and the substrate, thereby potentially extending the service life of the film. To increase the adhesion strength between the TiN film and the Mg alloy substrate, a Ti or Al interlayer was deposited on the Mg alloy by magnetron sputtering. Subsequently, the adhesion strengths of TiN/Ti and TiN/Al were determined under a single high shear force by scratch tests and were determined under multiple low shear forces by friction and wear tests. The results of scratch tests show that TiN with the Ti interlayer on the Mg alloy substrate has superior adhesion strength under a single high shear force. And the results of friction and wear tests show that both the TiN/Al and TiN/Ti films provided protection to the Mg alloy substrate against friction and wear, and TiN with the Ti interlayer on the Mg alloy substrate has superior adhesion strength under multiple low shear forces. This work can provide guidance for the selection of interlayers between Mg alloy substrates and hard ceramic films.Keywords
Funding Information
- National Natural Science Foundation of China (51975564, 2022NSFSC0292)
- Natural Science Foundation of Sichuan province, China (51975564, 2022NSFSC0292)
This publication has 24 references indexed in Scilit:
- Ceramic coating for corrosion (c3) resistance of nuclear fuel claddingSurface and Coatings Technology, 2015
- Microstructure characterization and corrosion behaviour of a nano-hydroxyapatite coating deposited on AZ31 magnesium alloy using radio frequency magnetron sputteringVacuum, 2015
- Residual stresses in thin film systems: Effects of lattice mismatch, thermal mismatch and interface dislocationsInternational Journal of Solids and Structures, 2013
- Residual stress analysis of TiN film fabricated by plasma immersion ion implantation and deposition processNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2013
- The influence of residual thermal stresses on the mechanical properties of multilayer α-Al2O3/TiCxN1−x coatings on WC/Co cutting toolsSurface and Coatings Technology, 2013
- Microstructure and property of friction stir welding joint of 7075Al and AZ31BMgJournal of Shanghai Jiaotong University (Science), 2012
- Effect of Cr interlayer on the adhesion and corrosion enhancement of nanocomposite TiN-based coatings deposited on stainless steel 410Thin Solid Films, 2011
- The influence of metallic interlayers on the adhesion of PVD TiN coatings on high-speed steelWear, 2008
- Characterization of reactive magnetron sputtered nanocrystalline titanium nitride (TiN) thin films with brush plated Ni interlayerJournal of Applied Electrochemistry, 2007
- A comparative study on cutting performance of TiN-coated tungsten carbide cutting tool with a cobalt interlayerSurface and Coatings Technology, 2005