In-Situ Synthesis of Cu/Cr-Al2O3 Nanocomposite by Mechanical Alloying and Heat Treatment
Authors:
- 26 June 2010
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 41 (10) , 2606-2612
Abstract
No abstract availableKeywords
This publication has 22 references indexed in Scilit:
- Mechanical alloying and millingProgress in Materials Science, 2001
- Abrasive wear behavior of TiB2 particle-reinforced copper matrix compositesMaterials Science and Engineering: A, 2000
- Microstructure and properties of titanium boride dispersed Cu alloys fabricated by spray formingMaterials Science and Engineering: A, 2000
- Effects of Al additive on the mechanical and physical properties of silicon reinforced copper matrix compositesScripta Materialia, 1999
- Alumina-chromium cermets by hot-pressing of nanocomposite powdersJournal of the European Ceramic Society, 1998
- Cu precipitation in Cr ribbon of Cu-15 wt % Cr in situ compositeApplied Physics Letters, 1996
- Correlation of microstructure and type II superconductivity of a heavily cold rolled Cu-20mass% Nb in situ compositeActa Materialia, 1996
- Microstructure and strength of CuFe in Situ composites after very high drawing strainsActa Materialia, 1996
- On the stability of cold drawn, two-phase wiresActa Metallurgica et Materialia, 1995
- Anomalous combustion effects during mechanical alloyingMetallurgical Transactions A, 1991