Detectability of Bearing Failure of Composite Bolted Joints by Electric Resistance Change Method
Authors:
- 15 October 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 321-323, 957-962
Abstract
Bolted joints are widely used for composite structures. As is well known, excessive bearing load gives rise to bearing failure at hole boundaries. Detecting bearing failure is important for assuring integrity of composite structures. Since conventional nondestructive inspection methods are expensive, cumbersome, time-consuming, and not suitable for health monitoring, a simple, low-cost inspection method for bearing failure must be developed. Authors have demonstrated the feasibility of detecting bearing failure by using an electric resistance change method. In this study, more detailed analyses were carried out to investigate the detectability in terms of the damage size and the distance between damage and electrodes. The results show that bearing failure of less than 10mm square causes the electric resistance change of a few hundred ppm and thus can be easily detected, and that the electrodes can be mounted more than 10 mm far from a bolt hole.Keywords
This publication has 29 references indexed in Scilit:
- Stress analysis and strength prediction of mechanically fastened joints in FRP: a reviewComposites Part A: Applied Science and Manufacturing, 1997
- Electrical resistance measurement technique for detecting failure in CFRP materials at high strain ratesComposites Science and Technology, 1994
- Carbon fiber reinforced concrete for smart structures capable of non-destructive flaw detectionSmart Materials and Structures, 1993
- Electrical crack length measurement and the temperature dependence of the Mode I fracture toughness of carbon fibre reinforced plasticsComposites Science and Technology, 1993
- Load and failure analyses of CFRP laminates by means of electrical resistivity measurementsComposites Science and Technology, 1989
- The strength of bolted joints in glass fibre/epoxy laminatesComposites, 1985
- The electrical properties of joints in carbon fibre compositesComposites, 1982
- On the bearing strengths of cfrp laminatesComposites, 1982
- The Effect of Stacking Sequence on the Pin-Bearing Strength in Glass Fibre Reinforced PlasticJournal of Composite Materials, 1977
- The strength of bolted joints in multi-directional cfrp laminatesComposites, 1977