Mechanical bonding in cold roll-cladding of tri-layered brass/steel/brass composite
Authors:
- 1 October 2020
- journal article
- research article
- Published by Walter de Gruyter GmbH in International Journal of Materials Research
- Vol. 111 (10) , 826-832
Abstract
In this paper, brass/steel/brass clad-composite was fabricated using a cold roll-bonding process. Composite sheets were roll-bonded at reduction ratios between 37 and 72% at room temperature from strips of 150 mm in length and 30 mm wide, in one pass without lubrication. The threshold deformation for successful bonding was at a thickness reduction of 48% and peel strengths of the bonds were measured to be approximately 12 N cm-1, and it was found to escalate with an increase in the rolling reduction. The optimum reduction in thickness was ~66% wherein the peel strength was ~33 N cm-1. Various techniques such as optical and electron microscopy were implemented to analyze and investigate the effects of the reduction in thickness and the joining mechanism. The results showed that an increased reduction in thickness in rolling leads to an increase in the joining strength. Furthermore, increasing the brass plate thickness negatively affects the joining strength. A Cu peak on the peeled-off steel surface and the presence of Fe on the peeled-off brass surface strongly suggest that the major bonding between brass and steel was mechanically induced metallurgical bonding.Keywords
This publication has 23 references indexed in Scilit:
- Estimating interface bonding strength in clad metals using digital image correlationScripta Materialia, 2013
- Effect of annealing on the interface microstructure and mechanical properties of a STS–Al–Mg 3-ply clad sheetMaterials Science and Engineering: A, 2012
- Investigation on the bond strength of Al-1100/St-12 roll bonded sheets, optimization and characterizationMaterials & Design (1980-2015), 2011
- High-strength and highly-uniform composite produced by anodizing and accumulative roll bonding processesMaterials & Design (1980-2015), 2010
- Effective parameters on bonding strength of roll bonded Al/St/Al multilayer stripsJournal of Alloys and Compounds, 2009
- Investigation of roll bonding between aluminum alloy stripsMaterials & Design (1980-2015), 2008
- A combined texture and FEM study of strain states during roll-cladding of five-ply stainless steel/aluminum compositesMaterials Science and Engineering: A, 2007
- Solid-state bonding of iron-based alloys, steel–brass, and aluminum alloysJournal of Materials Processing Technology, 1998
- Factors Influencing the Fatigue Behavior of Ferrous LaminatesJournal of Engineering Materials and Technology, 1987
- Deformation and diffusion bonding of aluminidecoated steelsThin Solid Films, 1984