Electronically Conducting Doped Chromium Oxides
Authors:
- 1 July 1984
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 67 (7) , 498-503
Abstract
Samples of polycrystalline chromium oxide doped with Li 2 O, MgO, NiO, and Ta 2 O 5 were prepared by hot‐pressing to test for suitability as current collector materials of the sulfur electrode in the sodium‐sulfur cell. Density, grain size, dopant uniformity, and resistivity (to 350°C) were measured. X‐ray photoelectron spectroscopy (XPS) tends to support the established model of Ni 2+ on Cr 3+ sites to explain the compositional dependence of electrical resistivity after air anneal. A higher level of Cr 2 O 3 powder purity was required to obtain the low resistivities with the Li 2 O dopant than with the MgO or NiO dopant. An observed increase in the bulk resistivity during several months of electrochemical cycling in sodium polysulfidelsulfur melts is attributed to loss of electronic carriers caused by equilibration of those carriers with the low oxygen partial pressure of the melt. Li 2 O‐ and (to a lesser extent) MgO‐doped Cr 2 O 3 appear to be suitable as container coating materials.Keywords
This publication has 9 references indexed in Scilit:
- Oxygen Activity Dependence of the Electrical Conductivity of Li‐Doped Cr 2 O 3Journal of the American Ceramic Society, 1984
- Solubility of metal sulfides in sodium polysulfide meltsJournal of Chemical & Engineering Data, 1979
- Electrical conduction in Fe2O3 and Cr2O3Solid State Communications, 1974
- Initial Sintering of Cr 2 O 3Journal of the American Ceramic Society, 1974
- Final Sintering of Cr2O3Journal of the American Ceramic Society, 1972
- Thermodynamic and Physical Properties of Molten Sodium Polysulfides from Open-Circuit Voltage MeasurementsJournal of the Electrochemical Society, 1972
- The Transport Properties and Defect Structure of the Oxide (Fe, Cr)2O3formed on Fe-Cr alloysMaterials and Corrosion, 1970
- Über die Kinetik des Einbaues von gleich- und niederwertigen Fremdzusätzen in das Chrom(III)oxid und ihre Auswirkung auf die elektrischen EigenschaftenZeitschrift für Physikalische Chemie, 1964
- Elektrische Widerstands- und Thermokraftmessungen an Chrom(III)-oxyd bei Temperaturen bis 1750°Archiv für das Eisenhüttenwesen, 1957