Unraveling Anisotropy in Crystalline Orientation under Shock-Induced Dynamic Responses in High-Entropy Alloy Co25Ni25Fe25Al7.5Cu17.5
Open Access
- 29 August 2023
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 13 (17) , 2446
Abstract
Shock-induced plastic deformation and spall damage in the single-crystalline FCC Co25Ni25Fe25Al7.5Cu17.5 high-entropy alloy (HEA) under varying shock intensities were systematically investigated using large-scale molecular dynamics simulations. The study reveals the significant influence of crystalline orientation on the deformation mechanism and spall damage. Specifically, the shock wave velocities in the [110] and [111] directions are significantly higher than that in the [001] direction, resulting in a two-zone elastic-plastic shock wave structure observed in the [110] and [111] samples, while only a single-wave structure is found in the [001] sample. The plastic deformation is dominated by the FCC to BCC transformation following the Bain path and a small amount of stacking faults during the compression stage in the [001] sample, whereas it depends on the stacking faults induced by Shockley dislocation motion in the [110] and [111] samples. The stacking faults and phase transformation in the [001] sample exhibit high reversibility under release effects, while extensive dislocations are present in the [110] and [111] samples after release. Interestingly, tension-strain-induced FCC to BCC phase transformation is observed in the [001] sample during the release stage, resulting in increased spall strength compared to the [110] and [111] samples. The spall strength estimated from both bulk and free surface velocity history shows reasonable consistency. Additionally, the spall strength remains stable with increasing shock intensities. The study discusses in detail the shock wave propagation, microstructure change, and spall damage evolution. Overall, our comprehensive studies provide deep insights into the deformation and fracture mechanisms of Co25Ni25Fe25Al7.5Cu17.5 HEA under shock loading, contributing to a better understanding of dynamic deformation under extreme environments.Keywords
Funding Information
- National Natural Science Foundation of China-NSAF (U2030117, 12132003)
- State Key Program of the National Natural Science Foundation of China (U2030117, 12132003)
This publication has 47 references indexed in Scilit:
- Shock responses of nanoporous aluminum by molecular dynamics simulationsInternational Journal of Plasticity, 2017
- High-velocity deformation of Al0.3CoCrFeNi high-entropy alloy: Remarkable resistance to shear failureScientific Reports, 2017
- Microstructure and strengthening mechanisms in an FCC structured single-phase nanocrystalline Co25Ni25Fe25Al7.5Cu17.5 high-entropy alloyActa Materialia, 2016
- Computational Analysis Methods in Atomistic Modeling of CrystalsJOM, 2013
- Sluggish diffusion in Co–Cr–Fe–Mn–Ni high-entropy alloysActa Materialia, 2013
- Automated identification and indexing of dislocations in crystal interfacesModelling and Simulation in Materials Science and Engineering, 2012
- Structure identification methods for atomistic simulations of crystalline materialsModelling and Simulation in Materials Science and Engineering, 2012
- The Bain path of paramagnetic Fe-Cr based alloysJournal of Applied Physics, 2011
- Visualization and analysis of atomistic simulation data with OVITO–the Open Visualization ToolModelling and Simulation in Materials Science and Engineering, 2009
- Hugoniot and strength behavior of silicon carbideJournal of Applied Physics, 2006