Turbulence characteristics of a boundary layer over a swept bump
Authors:
- 25 September 1996
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 323, 1-22
Abstract
The evolution of the turbulent boundary layer over a bump defined by three tangential circular arcs and swept at 45° was examined. The flat-plate boundary layer approaching the swept bump had a momentum thickness Reynolds number of approximately 3800. The ratios of upstream boundary-layer thickness to bump height and convex radius of curvature were 1.5 and 0.06, respectively. The boundary layer was influenced by alternating signs of streamwise pressure gradient, wall curvature, and mean crossflow, which resulted in a complex boundary-layer flow that grew rapidly on the downstream side of the bump. The mean flow profiles deviated significantly from typical logarithmic layer behaviour, but the flow remained attached. The evolution of the Reynolds stress components was explained by the growth of two internal layers triggered by discontinuities in wall curvature near the leading and trailing edges of the bump. The shear stress vector was found to lag the velocity gradient vector, despite the spanwise flow changing direction above the bump. The measurements were compared to the previous results from a two-dimensional bump with the same profile shape and Reynolds number. Contrary to previous studies, the addition of mean crossflow to this complex flow field did not reduce the vertical mixing relative to the turbulent kinetic energy.Keywords
This publication has 17 references indexed in Scilit:
- Boundary-Layer Transition and Global Skin Friction Measurement with an Oil-Fringe Imaging TechniqueSAE International Journal of Advances and Current Practices in Mobility, 1993
- Low-Reynolds-number turbulent boundary layersJournal of Fluid Mechanics, 1991
- Reynolds stress development in pressure-driven three-dimensional turbulent boundary layersJournal of Fluid Mechanics, 1989
- Three-component LDA measurements in a turbulent boundary layerExperiments in Fluids, 1988
- Turbulent boundary-layer flow and structure on a convex wall and its redevelopment on a flat wallJournal of Fluid Mechanics, 1983
- A new surface-streamline flow-visualization techniqueJournal of Fluid Mechanics, 1982
- Turbulence measurements in an adverse-pressure-gradient three-dimensional turbulent boundary layer along a circular cylinderJournal of Fluid Mechanics, 1981
- Measurements in an incompressible three-dimensional turbulent boundary layer, under infinite swept-wing conditions, and comparison with theoryJournal of Fluid Mechanics, 1975
- Measurements in a three-dimensional turbulent boundary layer induced by a swept, forward-facing stepJournal of Fluid Mechanics, 1970
- Calibration of the Preston tube and limitations on its use in pressure gradientsJournal of Fluid Mechanics, 1965