Bulk properties of synthetic polymer‐inorganic salt systems. V. Mechanical properties of oriented poly(caproamide)
Authors:
- 1 November 1979
- journal article
- research article
- Published by Wiley in Journal of Polymer Science: Polymer Physics Edition
- Vol. 17 (11) , 1903-1912
Abstract
Single filaments of nylon‐6 and of its mixtures with KCl, LiCl, and LiBr (salt content up to 5% w/w) were prepared by extrusion at 265°C. As‐spun filaments with a varying degree of orientation were obtained by altering the take‐up velocity a t constant outflow velocity. These as‐spun filaments were further subjected to controlled thermal and mechanical treatments. Determinations of the elastic modulus, of birefringence, of wide‐angle x‐ray scattering, and of shrinkage were carried out for the as‐spun and for the treated filaments. While KCl caused no detectable alteration of the properties of nylon‐6, lithium halides caused a considerable increase of the elastic modulus of the polymer. Under the conditions adopted, moduli up to 14 GPa were obtained. The birefringence of as‐spun fibers was, however, lower when lithium salt was present. Greater shrinkage a t 170°C was exhibited by the salted than by the pure polymer. The body of results has been interpreted in terms of a more efficient orientation of the extruded polymer when lithium salt is present. The latter effect is associated with the role of these salts in reducing the crystallization rate and in increasing the melt viscosity of the polyamide as characterized in preceding papers of this series. Lithium salts also favor the α → γ transformation between the two crystalline forms of nylon‐6. The transformation was, however, reversed under sufficiently high applied stress.Keywords
This publication has 8 references indexed in Scilit:
- Increasing the elastic modulus of polyamidesJournal of Polymer Science Part C: Polymer Letters, 1977
- On the crystal structure of nylon 6Journal of Applied Polymer Science, 1977
- Bulk Properties of Synthetic Polymer-Inorganic Salt Systems. IV. Role of the Polymeric SubstrateMacromolecules, 1976
- Bulk Properties of Synthetic Polymer-Inorganic Salt Systems. II. Crystallization Kinetics of Salted Poly(caproamide)Macromolecules, 1974
- Bulk properties of synthetic polymer-inorganic salt systems. Melting behavior of salted poly(caproamide)The Journal of Physical Chemistry, 1973
- Studies on the orientation phenomena by fiber formation from polymer melts. III. Effect of structure on orientation. Condensation polymersJournal of Applied Polymer Science, 1962
- Über die mesomorphe β-Form von Polycapronamid und ihre Umwandlung in die kristalline Form αColloid and Polymer Science, 1959
- The Theory of Permanent Set at Elevated Temperatures in Natural and Synthetic Rubber VulcanizatesJournal of Applied Physics, 1946