Accuracy of Three-dimensional Cone Beam Computed Tomography Digital Model Measurements Compared with Plaster Study Casts
Open Access
- 1 October 2017
- journal article
- research article
- Published by Scientific Scholar in APOS Trends in Orthodontics
- Vol. 7 (5) , 215-218
Abstract
Purpose: The purpose of this study was to assess the accuracy of three-dimensional (3D) cone beam computed tomography (CBCT) study casts by comparing with direct measurements taken from plaster study casts. Materials and Methods: The dental arches of 30 patient subjects were imaged with a Kodak 9300 3D CBCT devise; Anatomodels were created and in vivo 5 imaging software was used to measure 10 dental arch variables which were compared to measurements of plaster study casts. Results: Three of the 10 variables, i.e., overbite, maxillary intermolar width, and arch length, were found significantly smaller (P < 0.05) using the Anatomodels following nonparametric Wilcoxon signed-rank testing. None of the differences found in the study averaged <0.5 mm. Conclusions: 3D CBCT imaging provided clinically acceptable accuracy for dental arch analysis. 3D CBCT imaging tended to underestimate the actual measurement compared to plaster study casts.Keywords
This publication has 18 references indexed in Scilit:
- A comparison between dental measurements taken from CBCT models and those taken from a Digital MethodEuropean Journal of Orthodontics, 2011
- Operational Principles for Cone-Beam Computed TomographyThe Journal of the American Dental Association, 2010
- Accuracy of linear measurements from cone-beam computed tomography-derived surface models of different voxel sizesAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2010
- Apologia for the Status QuoRussian Politics & Law, 2008
- Three-dimensional accuracy of measurements made with software on cone-beam computed tomography imagesAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2008
- Linear Accuracy and Reliability of Cone Beam CT Derived 3-Dimensional Images Constructed Using an Orthodontic Volumetric Rendering ProgramThe Angle Orthodontist, 2008
- Large scan field, high spatial resolution flat-panel detector based volumetric CT of the whole human skull base and for maxillofacial imagingDentomaxillofacial Radiology, 2007
- Three-dimensional digital modeling and setupAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2006
- A comparison of craniofacial morphology in patients with and without facial asymmetry—a three-dimensional analysis with computed tomographyInternational Journal of Oral and Maxillofacial Surgery, 2006
- Fusion of computed tomography data and optical 3D images of the dentition for streak artefact correction in the simulation of orthognathic surgeryDentomaxillofacial Radiology, 2004