Effect of Copper Precursors on Catalytic Performance Over CuO–CeO 2 Toward NH 3 ‐SCR Reaction
Open Access
- 30 September 2026
- journal article
- research article
- Published by Wiley in ChemistrySelect
- Vol. 11 (37) , e74652
Abstract
The NH 3 ‐SCR performance of CuO‐CeO 2 catalysts is highly sensitive to the selection of copper precursors, yet the structure‐activity relationship under the influence of phosphorus‐containing precursors has not been systematically elucidated to date. Herein, CuCe(P) was first prepared via coprecipitation using copper phosphate precursor and systematically compared with CuCe(N) and CuCe(S) from conventional copper nitrate and sulfate, respectively. The results showed that the CuCe(P) catalyst reached a NO x conversion rate of 89.5% at 300°C with an N 2 selectivity of 95% at 350°C–450°C. The introduction of PO 4 3− enhanced interactions between CuO x and CeO 2 support, promoting oxygen vacancy formation, increasing surface acidity, and reactive oxygen species concentration. Lewis acid sites were the primary species on the surface of the CuCe(P) catalyst. NH 3 was mainly adsorbed onto these acid sites and participated in the reaction process. The catalyst operated via both the Eley‐Rideal mechanism and the Langmuir‐Hinshelwood mechanism in parallel. Furthermore, excessive nitrate species formation was effectively suppressed by phosphate modification, which reduced the occupation of active sites. This study provides scientific guidance for the rational design of phosphorus‐modified Cu‐Ce based SCR catalysts and an effective approach to address the key challenge of balancing activity and selectivity in medium‐to‐high‐temperature SCR catalysis.Keywords
Funding Information
- National Natural Science Foundation of China (21872096)
This publication has 66 references indexed in Scilit:
- A dual-balance strategy via phosphate modification on MnO2-CeO2 for NO and chlorobenzene synergistic catalytic controlApplied Catalysis B: Environment and Energy, 2023
- Electrocatalytic nitrate reduction to ammonia on defective Au1Cu (111) single-atom alloysApplied Catalysis B: Environment and Energy, 2022
- Efficient propane low-temperature destruction by Co3O4 crystal facets engineering: Unveiling the decisive role of lattice and oxygen defects and surface acid-base pairsApplied Catalysis B: Environment and Energy, 2021
- Interaction of Hydrogen with Ceria: Hydroxylation, Reduction, and Hydride Formation on the Surface and in the BulkChemistry – A European Journal, 2020
- Deactivation mechanism of Cu active sites in Cu/SSZ-13 — Phosphorus poisoning and the effect of hydrothermal agingApplied Catalysis B: Environment and Energy, 2020
- Deactivation of Cu-SSZ-13 SCR catalysts by vapor-phase phosphorus exposureApplied Catalysis B: Environment and Energy, 2019
- Phosphorus modification to improve the hydrothermal stability of a Cu-SSZ-13 catalyst for selective reduction of NOx with NH3Applied Catalysis B: Environment and Energy, 2019
- Efficiency of Cu and Pd substitution in Fe-based perovskites to promote N2 formation during NH3 selective catalytic oxidation (NH3-SCO)Applied Catalysis B: Environment and Energy, 2017
- Selective catalytic oxidation of ammonia to nitrogen over CuO-CeO2 mixed oxides prepared by surfactant-templated methodApplied Catalysis B: Environment and Energy, 2013
- The role of copper species on Cu/γ-Al2O3 catalysts for NH3–SCO reactionApplied Surface Science, 2012