Reliability of the Load-Velocity Relationship and Validity of the PUSH to Measure Velocity in the Deadlift
Authors:
- Ludwig RufLRLudwig Ruf
- 1 September 2019
- journal article
- research article
- Published by Wolters Kluwer Health in Journal of Strength & Conditioning Research
- Vol. 33 (9) , 2370-2380
Abstract
Chéry, C and Ruf, L. Reliability of the load-velocity relationship and validity of the PUSH to measure velocity in the deadlift. J Strength Cond Res 33(9): 2370–2380, 2019—This study investigated the reliability between load and mean velocity, mean propulsive velocity, peak velocity, mean power, and peak power in the deadlift. Also, we looked at the validity of an inertial sensor (PUSH) and a linear-position transducer (Tendo) to measure velocity variables. Ten strength-trained men (23.4 ± 1.3 years) were involved in three 1 repetition maximum (1RM) testing sessions, separated by at least 72 hours. The protocol used 6 different lifting intensities, comprising 20, 40, 60, 80, 90, and 100% of 1RM. Reliability of the load-velocity and load-power relationship was assessed by comparing velocity and power measurements from session 2 and 3 for each relative %1RM. The validity of tested devices was analyzed regarding to each relative intensity by comparing results from each instrument to a reference instrument (GymAware). The findings revealed that intermediate intensities (ranging from 60 to 90% of 1RM) seem to be reliable. Furthermore, extreme points of the load-velocity curve (20, 40, and 100% of 1RM) were found to be less reliable and should therefore be used with caution when implemented as part of autoregulating strategies. Tendo produced measurements that were highly correlated with GymAware and thus, constitutes a valid and cheaper alternative. By contrast, measurements from the PUSH presented a low level of precision and accuracy. Therefore, PUSH cannot be considered as a valid tool to measure velocity variables in the deadlift.Keywords
This publication has 26 references indexed in Scilit:
- Force–velocity relationship of leg extensors obtained from loaded and unloaded vertical jumpsEuropean Journal of Applied Physiology, 2014
- Why is the force-velocity relationship in leg press tasks quasi-linear rather than hyperbolic?Journal of Applied Physiology, 2012
- Optimal Force–Velocity Profile in Ballistic Movements—AltiusMedicine & Science in Sports & Exercise, 2012
- Validating Two Systems for Estimating Force and PowerInternational Journal of Sports Medicine, 2011
- Using the load-velocity relationship for 1RM predictionJournal of Strength & Conditioning Research, 2011
- Assessing the Force-Velocity Characteristics of the Leg Extensors in Well-Trained Athletes: The Incremental Load Power ProfileJournal of Strength & Conditioning Research, 2008
- Importance of Upper-Limb Inertia in Calculating Concentric Bench Press ForceJournal of Strength & Conditioning Research, 2008
- Effect of Loading on Unintentional Lifting Velocity Declines During Single Sets of Repetitions to Failure During Upper and Lower Extremity Muscle ActionsInternational Journal of Sports Medicine, 2005
- Force/velocity and power/velocity relationships in squat exerciseEuropean Journal of Applied Physiology, 2001
- Circadian Variation in Sports PerformanceSports Medicine, 1996