Design of Parallel Air-Cooled Battery Thermal Management System through Numerical Study
Open Access
Abstract
In electric vehicles, the battery pack is one of the most important components that strongly influence the system performance. The battery thermal management system (BTMS) is critical to remove the heat generated by the battery pack, which guarantees the appropriate working temperature for the battery pack. Air cooling is one of the most commonly-used solutions among various battery thermal management technologies. In this paper, the cooling performance of the parallel air-cooled BTMS is improved through choosing appropriate system parameters. The flow field and the temperature field of the system are calculated using the computational fluid dynamics method. Typical numerical cases are introduced to study the influences of the operation parameters and the structure parameters on the performance of the BTMS. The operation parameters include the discharge rate of the battery pack, the inlet air temperature and the inlet airflow rate. The structure parameters include the cell spacing and the angles of the divergence plenum and the convergence plenum. The results show that the temperature rise and the temperature difference of the batter pack are not affected by the inlet air flow temperature and are increased as the discharge rate increases. Increasing the inlet airflow rate can reduce the maximum temperature, but meanwhile significantly increase the power consumption for driving the airflow. Adopting smaller cell spacing can reduce the temperature and the temperature difference of the battery pack, but it consumes much more power. Designing the angles of the divergence plenum and the convergence plenum is an effective way to improve the performance of the BTMS without occupying more system volume. An optimization strategy is used to obtain the optimal values of the plenum angles. For the numerical cases with fixed power consumption, the maximum temperature and the maximum temperature difference at the end of the five-current discharge process for the optimized BTMS are respectively reduced by 2.1 K and 4.3 K, compared to the original system.Keywords
Funding Information
- National Natural Science Foundation of China (51506056, 51536003)
- the Fundamental Research Funds for the Central Universities (2017MS017)
- National Undergraduate Innovative Training Program (201710561094)
This publication has 30 references indexed in Scilit:
- Thermal performance of lithium-ion battery thermal management system by using mini-channel coolingEnergy Conversion and Management, 2016
- Investigation of the thermal performance of phase change material/mini-channel coupled battery thermal management systemApplied Energy, 2016
- Thermal management optimization of an air-cooled Li-ion battery module using pin-fin heat sinks for hybrid electric vehiclesJournal of Power Sources, 2015
- Thermal analysis and two-directional air flow thermal management for lithium-ion battery packJournal of Power Sources, 2014
- Simulative method for determining the optimal operating conditions for a cooling plate for lithium-ion battery cell modulesJournal of Power Sources, 2014
- Combined experimental and numerical study of thermal management of battery module consisting of multiple Li-ion cellsInternational Journal of Heat and Mass Transfer, 2014
- State of charge estimation of lithium-ion batteries using the open-circuit voltage at various ambient temperaturesApplied Energy, 2014
- Thermal management of cylindrical batteries investigated using wind tunnel testing and computational fluid dynamics simulationJournal of Power Sources, 2013
- Design optimization of electric vehicle battery cooling plates for thermal performanceJournal of Power Sources, 2011
- Active (air-cooled) vs. passive (phase change material) thermal management of high power lithium-ion packs: Limitation of temperature rise and uniformity of temperature distributionJournal of Power Sources, 2008