Improvement of strength and ductility in a gradient structured Ni fabricated by severe torsion deformation
Authors:
- Liang YangLYLiang Yang
- Zhuo ChenZCZhuo Chen
- Xinkai MaXinkai Ma
- Dongling ZhongDZDongling Zhong
- Xiaojun ZhaoXZXiaojun Zhao
- Lei XiaoLXLei Xiao
- Xiaotian FangXFXiaotian Fang
- 1 October 2021
- journal article
- research article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 826
Abstract
No abstract availableKeywords
This publication has 40 references indexed in Scilit:
- Enhancing tensile strength of Cu by introducing gradient microstructures via a simple torsion deformationMaterials & Design, 2016
- Heterogeneous lamella structure unites ultrafine-grain strength with coarse-grain ductilityProceedings of the National Academy of Sciences, 2015
- Extraordinary strain hardening by gradient structureProceedings of the National Academy of Sciences, 2014
- Evading the strength–ductility trade-off dilemma in steel through gradient hierarchical nanotwinsNature Communications, 2014
- Improving tensile and compressive properties of magnesium alloy plates by pre-cold rollingScripta Materialia, 2012
- The influence of strain rate on the microstructure transition of 304 stainless steelActa Materialia, 2011
- Revealing Extraordinary Intrinsic Tensile Plasticity in Gradient Nano-Grained CopperScience, 2011
- Development of Nanostructures in Metallic Materials with Low Stacking Fault Energies During Surface Mechanical Attrition Treatment (SMAT)MATERIALS TRANSACTIONS, 2003
- Internal elastic strains in an IF steel following changes in strain pathActa Materialia, 1996
- Influences of cell walls and grain boundaries on transient responses of an if steel to changes in strain pathActa Metallurgica et Materialia, 1994