Comparison of dynamic and static hot wire anemometer calibrations for velocity perturbation measurements
Authors:
- 1 December 1976
- journal article
- Published by IOP Publishing in Journal of Physics E: Scientific Instruments
- Vol. 9 (12) , 1097-1100
Abstract
The sensitivity of constant temperature hot wire anemometers to velocity perturbations in an air flow was measured by the traditional static calibration technique as well as by the recently revived dynamic method in which the wire is shaken in a steady flow. Contrary to previously published findings, the two methods gave calibration constants which agreed to within an experimental standard error of 2% in the velocity range of 3-32 m s-1. A new signal processing technique was used for the dynamic calibration method which gave better accuracy in the presence of electronic noise and wind tunnel turbulence than the RMS method used to date.Keywords
This publication has 4 references indexed in Scilit:
- Turbulence Calibration of a Hot Wire AnemometerAIAA Journal, 1974
- An improved response equation for hot-wire anemometryInternational Journal of Heat and Mass Transfer, 1972
- Linearization and hot wire anemometryJournal of Physics E: Scientific Instruments, 1971
- Static and dynamic calibrations of constant-temperature hot-wire systemsJournal of Fluid Mechanics, 1971