Comparing Relative Bond Characteristics Between Spherical and Elongated Morphologies for Cold Spray Process Using SPH Simulation
Open Access
- 10 August 2022
- journal article
- research article
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 31 (8) , 2489-2504
Abstract
Under cold spray conditions, the modified Johnson–Cook model was adopted to perform single and multiple particle simulation for spherical and elongated aluminum alloy- Al-6061 feedstock particles. The splat formations were realistically presented; the temperature evolution throughout the deposition process stayed below the melting point of Al-6061, and the feedstock particles exhibited restitution for impact velocities lower than 200 m/s. Feedstock particles with elongated morphology experienced a lower elastic strain energy level than spherical morphology after impact, which implied the relative bond strength was higher for elongated particles than spherical particles. The displacement curves in single particle simulations for both morphologies suggested a spherical particle experienced a greater shock than the elongated particle upon impact. The relative bond strength achieved by multiple particle impact was lower than the single particle impact, even though the displacement curves showed the feedstock particles were individually embedded in the substrate.Keywords
Funding Information
- Swinburne University of Technology
This publication has 37 references indexed in Scilit:
- Constitutive modelling of plasticity of fcc metals under extremely high strain ratesInternational Journal of Plasticity, 2012
- Recent developments in explosive weldingMaterials & Design (1980-2015), 2011
- Bonding features and associated mechanisms in kinetic sprayed titanium coatingsActa Materialia, 2009
- Impact bonding and rebounding between kinetically sprayed titanium particle and steel substrate revealed by high-resolution electron microscopyJournal of Physics D: Applied Physics, 2009
- General aspects of interface bonding in kinetic sprayed coatingsActa Materialia, 2008
- Development of a generalized parameter window for cold spray depositionActa Materialia, 2006
- Adiabatic shear instability based mechanism for particles/substrate bonding in the cold-gas dynamic-spray processMaterials & Design (1980-2015), 2004
- A failure criterion based on material instabilityInternational Journal of Solids and Structures, 2003
- Crash-worthiness assessment of thin-walled structures with the high-strength steel sheetInternational Journal of Vehicle Design, 2002
- NUMERICAL MODELLING OF MICROSCALE EFFECTS IN CONDUCTION FOR DIFFERENT THERMAL BOUNDARY CONDITIONSNumerical Heat Transfer, Part A: Applications, 2000