Experimental Investigation of Two Switching States of an Active Foil Bearing during Start-Up
Open Access
Abstract
The next few years will be marked by major changes in the mobility sector in order to come closer to CO neutrality. Especially in the commercial vehicle sector, fuel cells can make an important contribution. In order to achieve this, the efficiency of all subcomponents of a vehicle has to be improved. This also includes the bearings in the electrical air compressors. The frequent start–stop cycles are critical, as they can lead to higher wear and thus a shorter service life. One solution is a prototype that can actively switch between a triangular profile and a round bearing shape. In this work, the two switching states are investigated experimentally. Instead of the thin bearing sleeve of the prototype, rigid sleeves are used for each switching shape. This allows the shape itself to be studied without the contribution of the stiffness of the thin bearing sleeve along with the actuators. The examination includes static load tests and run-out tests in the range of the lift-off speed. Alongside this, the difficulties of the bearing production and the improvement of the test rig used are pointed out.
Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (280508116)
This publication has 26 references indexed in Scilit:
- Effects of Mechanical Preloads on the Rotordynamic Performance of a Rotor Supported on Three-Pad Gas Foil Journal BearingsJournal of Engineering for Gas Turbines and Power, 2014
- A Metal Mesh Foil Bearing and a Bump-Type Foil Bearing: Comparison of Performance for Two Similar Size Gas BearingsJournal of Engineering for Gas Turbines and Power, 2012
- Rotordynamic Performance of Shimmed Gas Foil Bearings for Oil-Free TurbochargersJournal of Tribology, 2012
- Start-Stop Characteristics and Thermal Behavior of a Large Hybrid Airfoil Bearing For Aero-Propulsion ApplicationsJournal of Engineering for Gas Turbines and Power, 2011
- Experimental Analyses of a First Generation Foil Bearing: Startup Torque and Dynamic CoefficientsJournal of Engineering for Gas Turbines and Power, 2011
- Compliant Hybrid Journal Bearings Using Integral Wire Mesh DampersJournal of Engineering for Gas Turbines and Power, 2008
- Design, Fabrication, and Performance of Open Source Generation I and II Compliant Hydrodynamic Gas Foil BearingsTribology Transactions, 2008
- A Journal Bearing Test Rig With Reduced Uncertainty: Some Design ConsiderationsJournal of Testing and Evaluation, 2007
- An aerodynamic bearing with adjustable geometry and self-lifting capacity. Part 1: Self-lift capacity by squeeze filmProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2005
- A New Foil Air Bearing Test Rig for Use to 700°C and 70,000 rpmTribology Transactions, 1998