Microstructure and Mechanical Properties of ARB Processed Aluminium with Different Purities
Open Access
- 1 January 2016
- journal article
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 57 (10) , 1720-1728
Abstract
Were deformed to high strains by accumulative roll-bonding (ARB) at room temperature, and microstructure and mechanical properties were systematically characterized. During the ARB process, original coarse grains were subdivided by deformation-induced high-angle boundaries into nano-scale grains, where redundant shear strain introduced in the near-surface layers by friction in the non-lubricated rolling significantly accelerated the formation of nanostructures. It was found that spacing and fraction of high-angle boundaries can be explained by total equivalent strain taking the effect of shear strain into account. Quite uniform nanostructures dominated by high-angle boundaries were obtained after 6 cycles of ARB for 2N-Al and 4N-Al, but the boundary spacing was smaller in the 2N-Al than in the 4N-Al. On the other hand, in the case of 5N-Al, recrystallization and grain growth occurred during the roll-bonding process, and nanostructures were not able to be obtained. It was suggested that an increase in the amount of impurities is effective to increase the stability of the nanostructures and to randomize the deformation texture leading to a high fraction of high-angle boundaries.Keywords
This publication has 23 references indexed in Scilit:
- Effect of Deformation Temperature on Microstructure Evolution in ARB Processed Ultralow Carbon IF SteelMATERIALS TRANSACTIONS, 2012
- On the Onset of a Steady State in Body-Centered Cubic Iron during Severe Plastic Deformation at Low Homologous TemperaturesMetallurgical and Materials Transactions A, 2007
- Grain Size Saturation during Severe Plastic DeformationMaterials Science Forum, 2007
- Mechanical properties of nanocrystalline materialsProgress in Materials Science, 2006
- The transition from discontinuous to continuous recrystallization in some aluminium alloysActa Materialia, 2004
- Production of ultra-fine grain microstructures in Al–Mg alloys by coventional rollingActa Materialia, 2002
- Role of shear strain in ultragrain refinement by accumulative roll-bonding (ARB) processScripta Materialia, 2002
- Development of microstructure in FCC metals during cold workPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 1999
- Novel ultra-high straining process for bulk materials—development of the accumulative roll-bonding (ARB) processActa Materialia, 1999
- High angle boundaries formed by grain subdivision mechanismsActa Materialia, 1997