Supported Alumina Members by an in‐Situ Sol–Gel Method
Authors:
- 1 September 1992
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 75 (9) , 2613-2614
Abstract
Alumina membranes were prepared using a sol–gel process. Thin gel layers were grown onto porous alumina support tubes by using the permeation of water through the tube to control the rate of hydrolysis. Optimum coating conditions were found to be an ASB to 2‐propanol volume ratio of 1:25, coating times between 10 and 15 s, and partial drying times between 2.5 and 3 min, depending on whether the water was flowing in the tube or stored in the tube. The coatings remained crack‐free and adherent when fired to 800°C.Keywords
This publication has 6 references indexed in Scilit:
- Preparation and Characterization of High‐Temperature Thermally Stable Alumina Composite MembraneJournal of the American Ceramic Society, 1991
- Preparation of ?-alumina thin membrane by sol-gel processing and its characterization by gas permeationJournal of Materials Science, 1990
- Titania and alumina ceramic membranesJournal of Membrane Science, 1988
- Inorganic membranes obtained by sol-gel techniquesJournal of Membrane Science, 1988
- The preparation and characterization of alumina membranes with ultrafine pores. 2. The formation of supported membranesJournal of Colloid and Interface Science, 1985
- Alumina gels that form porous transparent Al2O3Journal of Materials Science, 1975