A Novel Finite-Control-Set Model Predictive Torque Control for Five-Phase PMSM With Improved Harmonic Current Suppression
Open Access
- 22 January 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 18677-18686
Abstract
There is the third harmonic current in five-phase permanent magnet synchronous motors (PMSMs), thus causing the distortion of stator currents and additional copper loss. Although the existing finite-control-set with virtual voltage vectors (FCS-V3s) can eliminate the harmonic voltage of harmonic subspace, it completely loses the ability to control the harmonic subspace. Moreover, the DC-link utilization is reduced due to the usage of V3s. To address these problems, a novel FCS model predictive torque control (FCS-MPTC) was proposed to be an alternative to the existing FCS-MPTC in this paper. First, a novel FCS was designed to achieve the double closed-loop control for both subspaces. Then, all the specific duty ratios were calculated and further limited to the normal range from the geometric point of view. Moreover, a wider amplitude range of available voltages was obtained in the novel FCS. Consequently, compared with the existing virtual-VVs-based FCS-MPTC (FCS-V3s-MPTC), the proposed method can effectively suppress the third harmonic current generated by the motor itself, improve the DC-link utilization while achieving the good steady-state and dynamic response performance. Finally, experimental results were presented to validate the effectiveness of proposed method.Keywords
Funding Information
- National Natural Science Foundation of China (52277052)
This publication has 25 references indexed in Scilit:
- A Multi-Mode High-Efficiency Fault-Tolerant Permanent Magnet MachineIEEE Transactions on Energy Conversion, 2023
- Simplified Universal Fault-Tolerant Direct Torque Control of FPFTPM Motor With Steady-Healthy Design Under Open-Circuit FaultIEEE Transactions on Industrial Electronics, 2021
- Improved Fault-Tolerant Model Predictive Torque Control of Five-Phase PMSM by Using Deadbeat SolutionIEEE Transactions on Energy Conversion, 2021
- Effect of Phase Shift on Inductance and Short-Circuit Current in Dual Three-Phase 48-Slot/22-Pole Permanent-Magnet MachinesIEEE Transactions on Industrial Electronics, 2021
- Disturbance-Observer-Based Direct Torque Control of Five-Phase Permanent Magnet Motor Under Open-Circuit and Short-Circuit FaultsIEEE Transactions on Industrial Electronics, 2020
- Enhanced Model Predictive Torque Control of Fault-Tolerant Five-Phase Permanent Magnet Synchronous Motor With Harmonic Restraint and Voltage PreselectionIEEE Transactions on Industrial Electronics, 2019
- A Constant Switching Frequency Multiple-Vector-Based Model Predictive Current Control of Five-Phase PMSM With Nonsinusoidal Back EMFIEEE Transactions on Industrial Electronics, 2019
- FOC Transformation for Single Open-Phase Faults in the Five-Phase Open-End Winding TopologyIEEE Transactions on Industrial Electronics, 2019
- Low-Complexity Model Predictive Torque Control Method Without Weighting Factor for Five-Phase PMSM Based on Hysteresis ComparatorsIEEE Journal of Emerging and Selected Topics in Power Electronics, 2018
- Asymmetrical SVPWM Fault-Tolerant Control of Five-Phase PM Brushless MotorsIEEE Transactions on Energy Conversion, 2016