Effect of light-activation methods and water storage on the flexural strength of two composite resins and a compomer
Authors:
- Silvia KenshimaSKSilvia Kenshima
- José Roberto de Oliveira BauerJosé Roberto de Oliveira Bauer
- Igor Studart MedeirosIMIgor Studart Medeiros
Open Access
- 1 April 2006
- journal article
- Published by FapUNIFESP (SciELO) in Brazilian Oral Research
- Vol. 20 (2) , 143-147
Abstract
The present study evaluated the flexural strength of three composite resins recommended for direct esthetic restorations: a polyacid modified composite (Dyract AP), a unimodal composite resin (Filtek Z250) and a hybrid composite resin (Point 4). The variation factors, apart from the type of composite resin, were the light activation method and the water storage period. The composite resins were light-cured in continuous mode (40 s, 500 mW/cm2) or in ramp mode (0-800 mW/cm2 for 10 s followed by 30 s at 800 mW/cm2) and stored for 24 hours or 30 days in distilled water at 37 degrees C. The data were analyzed by ANOVA and Tukey test for multiple comparisons (alpha = 0.05). The composite resin Z250 presented the highest mean flexural strength (166.74 MPa) and Dyract AP presented the lowest one (129.76 MPa). The storage for 30 days decreased the flexural strength in ramp mode (24 h: 156.64 MPa; 30 days: 135.58 MPa). The light activation method alone did not lead to different flexural strength values.Keywords
This publication has 18 references indexed in Scilit:
- Physical and mechanical properties of an experimental dental composite based on a new monomerDental Materials, 2004
- Curing efficiency and heat generation of various resin composites cured with high‐intensity halogen lightsEuropean Journal of Oral Sciences, 2004
- Comparison between a plasma arc light source and conventional halogen curing units regarding flexural strength, modulus, and hardness of photoactivated resin compositesClinical Oral Investigations, 2000
- Two-body in vitro wear study of some current dental composites and amalgamsThe Journal of Prosthetic Dentistry, 1999
- Effect of storage media on the fluoride release and surface microhardness of four polyacid-modified composite resins (“compomers”)Dental Materials, 1999
- Effect of water on the physical properties of resin-modified glass ionomer cementsDental Materials, 1999
- Leached components from dental composites in oral simulating fluids and the resultant composite strengthsJournal of Oral Rehabilitation, 1998
- Flexural Properties and Swelling after Storage in Water of Polyacid-modified Composite Resin (Compomer).Dental Materials Journal, 1998
- Setting stresses in composites for two different curing modesDental Materials, 1993
- Influence of Filler Type and Water Exposure on Flexural Strength of Experimental Composite ResinsJournal of Dental Research, 1988