An algorithm of galvanostatic pulse method to determine the corrosion status of reinforcement in concrete
Authors:
- Yan PeiyuYPYan Peiyu
- 1 April 2000
- journal article
- Published by Elsevier in Corrosion Science
- Vol. 42 (4) , 675-686
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Low frequency impedance data by Laplace transformation of coulostatically induced transientsElectrochimica Acta, 1998
- Evaluation of electrochemical impedance with constant phase angle component from the galvanostatic step response of steel in concreteElectrochimica Acta, 1996
- Comparing the steel-concrete interface state and its electrochemical impedanceCement and Concrete Research, 1996
- Advances in Electrochemical Impedance Measurements in Reinforced ConcreteMaterials Science Forum, 1995
- Programmable Linear Polarisation Meter for Determination of Corrosion Rate of Reinforcement in Concrete StructuresBritish Corrosion Journal, 1994
- Characterisation of steel/concrete interface by electrochemical impedance spectroscopyBritish Corrosion Journal, 1994
- An investigation of galvanostatic transient methods used to monitor the corrosion rate of steel in concreteCorrosion Science, 1993
- A galvanostatic pulse technique for investigation of steel corrosion in concreteCorrosion Science, 1988
- Errors in the electrochemical evaluation of very small corrosion rates—II. Other electrochemical techniques applied to corrosion of steel in concreteCorrosion Science, 1985
- Errors in the electrochemical evaluation of very small corrosion rates—I. polarization resistance method applied to corrosion of steel in concreteCorrosion Science, 1985