Experimental Investigation of Unsteady Flow Field in the Tip Region of an Axial Compressor Rotor Passage at Near Stall Condition With Stereoscopic Particle Image Velocimetry
Authors:
- 1 July 2004
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 126 (3) , 360-374
Abstract
Stereoscopic particle image velocimetry (SPIV) was applied to a large-scale low-speed compressor facility with the configuration of the two CCD cameras placed on each side of the light sheet to make the measurement of the vortices in the cross flow section possible and to avoid the disturbance from the light sheet containing periscope-type probe. Instantaneous velocity and vorticity distributions were successfully documented at the tip region of the rotor at near stall condition. The measurement results clearly revealed the generation and evolution of the tip leakage vortex. Comparing to design condition, the tip leakage vortex at near stall condition generates and breaks down earlier and interacts more violently with mainstream, which causes large blockage and much loss. Whether corner vortex exists or not is the primary difference between near stall and design condition. Differing from the leakage vortex, the corner vortex is composed of multiple vortices developed from the suction surface of the rotor blade. The key mechanism for the generation of the corner vortex is that the rotation of the rotor has different effect on the evolution of positive vortices and negative vortices, which makes the positive vortices dissipates faster than the negative ones, the vortices at the rotor exit therefore bear mainly negative vortices, which induces the fluids to rotate clockwise at the corner and forms the corner vortex.Keywords
This publication has 20 references indexed in Scilit:
- Measurement of the Three-Dimensional Tip Region Flow Field in an Axial CompressorJournal of Turbomachinery, 1993
- Experimental Study on the Three-Dimensional Flow Within a Compressor Cascade With Tip Clearance: Part II—The Tip Leakage VortexJournal of Turbomachinery, 1993
- Three-Dimensional Flow and Mixing in an Axial Flow Compressor With Different Rotor Tip ClearancesJournal of Turbomachinery, 1992
- Similarity Analysis of Compressor Tip Clearance Flow StructureJournal of Turbomachinery, 1991
- Tip Leakage Flow in Axial CompressorsJournal of Turbomachinery, 1991
- Structure of Tip Clearance Flow in an Isolated Axial Compressor RotorJournal of Turbomachinery, 1989
- Behavior of Tip Leakage Flow Behind an Axial Compressor RotorJournal of Engineering for Gas Turbines and Power, 1986
- Casing Wall Boundary-Layer Development Through an Isolated Compressor RotorJournal of Engineering for Power, 1982
- Three-Dimensional Flow Field in the Tip Region of a Compressor Rotor Passage—Part I: Mean Velocity Profiles and Annulus Wall Boundary LayerJournal of Engineering for Power, 1982
- TIP CLEARANCE FLOWS IN AXIAL FLOW COMPRESSORS AND PUMPS1954