Stress Corrosion Cracking Of Face-Centered-Cubic Alloys
Authors:
- 1 May 1965
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 21 (5) , 143-160
Abstract
Electron microscopy has been used to study the initial stages of stress corrosion cracking in some single phase copper-based alloys and an austenitic steel. Observations show that dislocations are subject to preferential dissolution, and are the principal sites of crack initiation in both intergranular and transgranular modes of failure. The transgranular cracks are initiated along {111} planes and are associated with alloys containing a planar arrangement of dislocations. Dissolution of dislocations is believed to be dependent upon segregation of solute atoms. A few studies on crack propagation are consistent with a mechanism of accelerated dissolution, supplemented by ductile tearing.Keywords
This publication has 21 references indexed in Scilit:
- Substitutional solution hardeningActa Metallurgica, 1963
- Direct measurements of stacking-fault energies from observations of dislocation nodesPhilosophical Magazine, 1961
- On the propagation of stress-corrosion cracks in metalsCorrosion Science, 1961
- On a surface energy mechanism for stress-corrosion crackingActa Metallurgica, 1961
- Stress corrosion in brass considered against the background of potential/pH diagramsElectrochimica Acta, 1961
- Some observations on the stress-corrosion cracking of α-brass and similar alloysPhilosophical Magazine, 1960
- Oxide nuclei and dislocationsActa Metallurgica, 1960
- Absolute interfacial energies of [001] tilt and twist grain boundaries in copperActa Metallurgica, 1959
- Dislocation etch pits in silicon ironActa Metallurgica, 1957
- Theory of the formation of lattice defects during plastic strainActa Metallurgica, 1955