Development of the UB Hand IV: Overview of Design Solutions and Enabling Technologies
- 4 June 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Robotics & Automation Magazine
- Vol. 20 (3) , 72-81
Abstract
The replication of the human hand's functionality and appearance is one of the main reasons for the development of robot hands. Despite 40 years of research in the field [1], the reproduction of human capabilities, in terms of dexterous manipulation, still seems unachievable by the state-of-the-art technologies. From a design perspective, even defining the optimal functionalities of a robotic end-effector is quite a challenging task since possible applications of these devices span industrial robotics, humanoid robotics, rehabilitation medicines, and prosthetics, to name a few. Therefore, it is reasonable to think that the design solutions, which are well suited to a single domain, might not be readily taken as general guidelines. For example, industrial manipulators are often equipped with basic grippers, which are conceived so as to increase the throughput and the reliability, and are assumed to operate in structured environments. In this case, the enhanced manipulation skills and the subsequent cost increases must be carefully motivated by the application requirements.Keywords
This publication has 26 references indexed in Scilit:
- Design of a Variable Stiffness Actuator Based on FlexuresJournal of Mechanisms and Robotics, 2011
- Comparative evaluation of the selective compliance in elastic joints for robotic structures2011
- Optimal Design of Lozenge-shaped Dielectric Elastomer Linear Actuators: Mathematical Procedure and Experimental ValidationJournal of Intelligent Material Systems and Structures, 2009
- The SDM Hand: A Highly Adaptive Compliant Grasper for Unstructured Environments2009
- The effect of series elasticity on actuator power and work output: Implications for robotic and prosthetic joint designRobotics and Autonomous Systems, 2006
- Design considerations for complementary inchworm actuatorsIEEE/ASME Transactions on Mechatronics, 2006
- Differential Hysteresis Modeling of a Shape Memory Alloy Wire ActuatorIEEE/ASME Transactions on Mechatronics, 2005
- A New Actuation Approach for Human Friendly Robot DesignThe International Journal of Robotics Research, 2004
- The BarrettHand grasper – programmably flexible part handling and assemblyIndustrial Robot: the international journal of robotics research and application, 2000
- Nets of tendons and actuators: an anthropomorphic model for the actuation system of dexterous robot hands1991