Calculation of Perforated Vertical and Horizontal Well Productivity in Low-Permeability Reservoirs
Authors:
- 12 December 2019
- journal article
- Published by Society of Petroleum Engineers (SPE) in SPE Drilling & Completion
- Vol. 35 (02) , 218-236
Abstract
Summary: This paper presents the productivity formulas of a perforated vertical well on the basis of the dual-radial-flow model and then presents the productivity formulas of horizontal wells on the basis of disturbing elliptical flow theory. The threshold pressure gradient (TPG) is used to characterize the seepage characteristics of low-permeability reservoirs. By combing the above formulas, the authors proposed the productivity formulas of perforated horizontal wells in a low-permeability reservoir on the basis of the triple-radial-flow model. The formulas are derived considering the cases of the damaged zone being penetrated and being partially penetrated. At the same time, the flow patterns of single-phase flow and oil/water two-phase flows are considered. Sensitivity analysis on the performance of the perforated well shows that the productivity increases with the increase of the length of the horizontal well, penetration depth, shot density, perforation diameter, and phasing, and it decreases with the increase of TPG, compaction thickness, and crush degree of the crushed zone; the influence of the length of the horizontal well, TPG, penetration depth, shot density, compaction degree, phasing, perforation diameter, and compaction thickness on the productivity is in descending order.Keywords
This publication has 9 references indexed in Scilit:
- Low velocity non-linear flow in ultra-low permeability reservoirJournal of Petroleum Science and Engineering, 2011
- Pseudo threshold pressure gradient to flow for low permeability reservoirsPetroleum Exploration and Development, 2009
- Behavior of Flow Through Low-Permeability Reservoirs2008
- Characterization of the Jet Perforation Crushed Zone by SEM and Image AnalysisSPE Formation Evaluation, 1994
- An Investigation of the Damaged Zone Created by Perforating1991
- Augmentation of Well Productivity With Slant and Horizontal Wells (includes associated papers 24547 and 25308 )Journal of Petroleum Technology, 1988
- The Effect of Perforating Conditions on Well PerformanceJournal of Petroleum Technology, 1983
- An Advanced Method for Predicting the Productivity Ratio of a Perforated WellJournal of Petroleum Technology, 1981
- Effect of Perforation Damage on Well ProductivityJournal of Petroleum Technology, 1974